Swift Owner's Handbook - Swift Group

Fitted Equipment240V Operation1. Turn off gas or 12V operation whenapplicable.2. Turn the knob (C) of the thermostat to itshighest (coldest) position.3. Set switch (B) to position I. The switch willlight up green when the power supply isconnected.12V OperationOnly operate your refrigerator on 12V whenthe engine of your vehicle is running. Installthrough a relay, otherwise your battery willsoon be discharged.Note: Before operating the refrigerator on12V, it should be pre-cooled, together with itscontents, by running it on bottled gas or240V for a few hours before changing over to12V and starting on a journey.1. If applicable turn off the gas operation.2. Set the 12V rocker switch (A) to I. Theswitch will light up red when the powersupply is connected.REGULATING THE TEMPERATUREThe position numbers refer to Fig. B.Once the refrigerator has been started it willtake a few hours to become cold.On 240V operation the refrigerator iscontrolled by a thermostat and thethermostat knob (C) should be set at 3-5. If alower (colder) temperature is desired, set thethermostat to a higher figure.On LP gas operation the refrigeratortemperataure is regulated by the gasthermostat knob (E), which should be set at3-5. If a lower (colder) temperature is desired,set the thermostat at a higher figure.On 12V operation the refrigerator workscontinuously.A BC D EFig. C Control Panel - RM4291MODEL RM4291 (86 litres)FTwo rocker switches are used to select theelectric power supply, one for 12V (A) andone for 240V (B) (see Fig. C).Refrigerator temperature is controlled by athermostat knob (C) when the refrigeratorruns on 240V.The refrigerator runs continuously on 12Voperation (no thermostat).The gas supply is turned ON/OFF by meansof the knob (D). When lighting the gas, theknob must be pressed as explained in LPGas Operation.Refrigerator temperature is controlled by athermostat (D) when the refrigerator runs onLP gas.52