Swift Owner's Handbook - Swift Group

ElectricsCascade/Pump IndicatorsThis module provides indicators for theCascade water heater fitted in your caravan.The three indicators show the following:Green LED - Heater is switched onRed LED- There has been a heaterfault, probably a low gassupplyYellow LED - DC voltage supply is too lowfor the heater to operateAlso included in this module is a pumprunning indicator. This red indicator will lightup as a warning when the water pump hasbeen activated.SWITCH MODULEThis module contains all the control switchesfor electrical facilities within the caravan.12V Isolation SwitchThis switch will effectively isolate 12 voltpower to all dc circuits by opening a relay.This switch should be used only whenwishing to isolate power for reasonably shortperiods (e.g. when going out for the day).For isolation during storage the Car/Vanswitch on the ESM2000 unit should be used(place Car/Van switch to the centre 'off'position).Pump switchThis switch merely energises the inboardwater pump ready for use. In caravans withan outboard pump, this switch will be a twoway type for energising whichever pump isrequired (i.e. internal or external)Entry Light switchThis switch energises an internal entry lightBattery/Water test switch(KT9/2000GT only)This switch should be pressed to the batteryposition to test battery voltage or the waterposition to test the water remaining in theinboard tank.Water Heater switchThis switch energises the gas ignition on theCarver water heater. When switched to the'on' position, the green indicator marked'heater on' should illuminate and the ignitionshould energise.ALARM MODULE - IDM 2000ImportantThis handbook should be read throughcarefully before any attempt is made toinstall and use the system. For case ofunderstanding it is suggested that thishandbook is read whilst viewing the keypad.Your alarm system, when new, contains themanufacturers code 1234. For securityreasons this should be changed as soon aspractical. (See 'Changing the PersonalCode').Factory SettingsEntry Delay - 0:00 (0 secs)Exit Delay - 0:20 (20 secs)Siren On Time - 1:00 (1 minute)ManufacturersPersonal Code - 1234Changing the Personal Code1. Press "F", press "1"2. Enter the current code. (1234 if new).3. Enter desired 4 digit code.4. Press "F".5. This operation can be cancelled at anytime before step 4 by pressing "C".Changing the Entry Delay Time1. Press "F", press "0".2. Enter your personal code.3. Enter the new entry delay as 3 digits, i.e.10 seconds is entered 010.4. Press "F".5. This operation can be cancelled at anytime before step 3 by pressing "C".Note: The Entry Delay Time must be asshort as possible to prevent compromisingsecurity.42