Swift Owner's Handbook - Swift Group

Fitted EquipmentCARVER SPACE HEATERSPlease read these cautions before usingyour heater.In the event of a gas leak, immediatelyturn off all appliances and the gas supplyat the cylinder. Contact your nearestapproved service agent without delay.• The gas supply to the heater must befrom an approved pressure regulator ofadequate capacity. Under NOcircumstances should an industrial oradjustable regulator be used on caravans.• The heater must not be operated whilerefuelling or when the vehicle is in aconfined space such as a garage. The58heater MUST NOT be used if the flue hasbeen damaged.• The Carver 2000 and 5500 range ofheaters MUST NOT be used while thevehicle is in motion.• The products of combustion pass throughthe vehicle floor and requires unrestrictedair entry beneath the vehicle into which itis fitted. A minimum of 3 sides of thevehicle MUST be exposed at all times.This is to allow for dispersal of theunderfloor combustion products. If thereis a possibility of the sides becomingblocked by snow or mud, then the heaterMUST NOT be used. Every effort must bemade to clear obstructions before use.• There MUST NOT be a mantelpiece orshelving sited above the heater.• Curtains MUST NOT hang within 150mmof the sides of the heater, or within300mm above the top of the appliance.• DO NOT place furniture or upholsterycloser than 5mm to the sides of theheater.• Where children, the elderly or infirm arepresent, we recommend that a guard befitted around the heater when in use.• Always wait three minutes beforeattempting to relight the heater afterswitching off or the heater going in to failsafe shut down.• DO NOT obstruct the gap at the bottomof the heater or the outlet grille slots.• This heater does not contain anyasbestos or asbestos related products.• Aerosols and highly inflammable materialsMUST NOT be stored in compartmentsbehind or adjacent to the heater.• These heaters must be switched off andthe gas supply turned off while thevehicle is in motion.• When the heater is first used, it isrecommended that you open a window ordoor and turn the temperature setting tomaximum for one hour. This will allow anyodours when first using the appliance toescape. Note: If odours persist, contactyour local distributor.CARVER 2000P, 2000A and FANMASTERTo Light and Adjust the Heater - GasOperation1. Ensure the gas is turned on at thecylinder.2. Lighting the Heater:2000P, and 2000 FanmasterPress the control knob (3) down and turnto the ‘LOW/ ’ position (4) and thenpress firmly downwards. A click will beheard as the igniter operates, to light theheater. If a gas cylinder has beenreplaced, it may require severaloperations of the igniter to light the flame.