Swift Owner's Handbook - Swift Group

Electricsand battery voltage. To check the watercontents simply press the test switch to thewater position and the meter will display alevel on the following scale:Empty - 1 ⁄4 - 1 ⁄2 - 3 ⁄4 - FullTo test battery voltage simply press the testswitch to the battery position, readingsshould be taken as follows:Green region - Fully charged (no chargenecessary)Yellow region - Adequate charge(re-charge if desired)Red region - Low charge (turn oncharger switch to re-charge)Modules have a water pump runningindicator light.Cascade/Pump IndicatorsThis module provides indicators for theCascade water heater fitted in your caravan.The three indicators show the following:Green LEDRed LEDYellow LED36- Heater is switched on- There has been a heaterfault, probably a low gassupply- DC voltage supply is toolow for the heater to operateAlso included is a pump running indicator.This red indicator will light up as a warningwhen the water pump has been activated foreither INT or EXT pumps.SWITCH MODULEThis module contains the control switchesfor electrical facilities within the caravan.Pump switchThis switch merely energises whicheverpump is required (i.e. internal or external).On the panels there are two indicator lightsto show which pump is running.Car/Van selector switchThe car/caravan changeover switch providedin this module should be used in thefollowing way:Caravan positionWhen in this position dc power is availablefrom the caravan battery to power all 12 voltelectric circuits. If the charger is switchedon, the caravan battery will be charged upvia the charger/transformer unit.Central positionWhen in this position with the charger switchon, power is provided to all 12 volt circuitsvia the charger/transformer only. With thecharger off, all dc circuits are isolated. Note:The switch should be placed in this positionwhen the van is being towed.Car positionThe switch can be placed in this positionshould the caravan battery becomedischarged and no mains power is available.Note: First of all the towing vehicle should beelectrically connected to the caravan via the12S socket.Battery/Water test switchThis switch should be pressed to the batteryposition to test battery voltage or the waterposition to indicate the water remaining inthe inboard tank.Auto-fill Water SystemThe system controls the automatic filling ofthe internal fresh water tank from an externalpump.The Auto-fill water system is controlled bytwo switches:1. A start and stop switch sited in thePMS2000 indicator module.2. A manual override switch sited on thecontrol box positioned near the freshwater tank.OperationThe process begins when the Start-Stopswitch is briefly pressed at the side marked‘Start’, thus starting the external pump, theprocess can be stopped at any time bybriefly pressing the Start-Stop switch at theside marked ‘Stop’. The pump will run forapproximately 3 minutes or until the freshwater tank is full, at which point the Externalpump will automatically stop.Manual Override:- If the Automatic filling isnot required, an override switch has beenincluded on the Auto-Fill unit, situated nearthe internal fresh water tank.This switch has three positions:-