Tail Rotor Driveshaft Hanger

f(DBHT-212-CR&02. Fill groove between case and quillsleeves and around bearing retaining nutswith adhesive (C-308). Allow to cure for 72hours at room temperature.3. Remove oil filler cap. Mask filler capadapter, chip detector, oil level sight glass,couplings, and seals at outboard ends ofquills, and data plate.4. Spray paint gearbox with primer (C-246),coat 0.4 to 0.9 mil thickness.caln(DNOTEApply coating of coating (C-245), asp e r m a n u f a c t u r i n grecommendations, not less thanthirty minutes and not more thanfour hours after epoxy primer isapplied.5. DeletedDeleted6. DeletedNOTE7. Use brush to apply 1/2 inch (12.7 mm)diameter dot of white catalyzed epoxy paint(C-210) to oil cap and to gearbox case. Doton case should be placed on boss below oilcap adapter and directly above chip detector.65-20. Run-in and test.It is recommended that intermediate gearbox,after overhaul, be test run, and inspected inaccordance with Bell Helicopter Textron BHT-PUB-77-003, Run-in and Test Manual that isfurnished with run-in test stand. In the event arun-in stand not available, the functional test02).-ri1)D=+Cam'itsteaspecified in BHT-212-MM, may beaccomplished as minimum acceptablealternate test.65-21. INTERMEDIATE GEARBOX QUILLS''° ^°^p``LCDC1- C13(MO(On.-r(