Vectra Genisys Service Manual - DJO Global

5- TROUBLESHOOTING5.20 NIMH BATTERY MODULE CHECKS(CONTINUED)10. Using the Flat Blade Screwdriver, carefullyrelease the tabs retaining the top plate inposition. It will be necessary to lift withone hand while releasing the tabs withthe Screwdriver. See Figure 5.38.NOTE:Their are eight retaining tabs. All must bereleased as shown in Figure 5.38.11. Lift the PC Board and check the BatteryPacks to PC Board connection to ensure itis completely seated. See Figure 5.39.12. Visually Inspect individual cells of bothbattery packs for leaks or ruptures. SeeFigure 5.40.13. Reassemble the battery Module. Do notover tighten the two retaining screws inthe module top. Over tightening maydamage the threaded brass inserts of thehousing.Vectra Genisys®/Intelect Legend XT®/ Intelect® Vet Therapy SystemsFIGURE 5.38C. NiMH Battery Module Checks Results1. Should any check fail, replace the entiremodule. No component parts are or will bemade available for the Battery Module byChattanooga Group.2. If the problem persists, replace the ControlBoard.• NiMH batteries contain Class E corrosivematerials. In the event of battery cell ruptureor leakage, handle battery module wearingneoprene or natural rubber gloves. Contentsof a ruptured or leaking battery can causerespiratory irritation. Hypersensitivity tonickel can cause allergic pulmonary asthma.Contents of cell coming in contact with skincan cause skin irritation and chemical burns.• Never, under any circumstances, open thebattery cells. Should an individual cell from abattery become disassembled, spontaneouscombustion of the negative electrode ispossible. There can be a delay betweenexposure to air and spontaneous combustion.FIGURE 5.39FIGURE 5.4058