Vectra Genisys Service Manual - DJO Global

6- REMOVAL/REPLACEMENTVectra Genisys®/Intelect Legend XT®/ Intelect® Vet Therapy Systems6.13 MOUNTING AND DISMOUNTING THERAPYSYSTEM AND THERAPY SYSTEM CARTDISCONNECT THE SYSTEM FROM THE POWERSOURCE (OUTLET OR REMOVE BATTERY MODULE IFINSTALLED) BEFORE ATTEMPTING ANY MAINTENANCE,INSTALLATION, REMOVAL, OR REPLACEMENTPROCEDURES TO PREVENT ELECTRICAL SHOCK ANDPOSSIBLE DAMAGE TO SYSTEM.A. Mounting Therapy System toTherapy System Cart1. Remove all the Storage Bins from bothsides of the Therapy System Cart by pullingeach bin out and up. See Figure 6.49.2. Allow approximately 11.5 cm (4.5”) of thepower cord extending through the top ofthe cart for connecting to system. If thesystem is equipped with an optional NiMHBattery, Laser, or Channel 3/4 ElectrotherapyModule, it will be necessary to allow 16.5cm (6.5”) of the Power Cord extendingthrough the top of the Therapy SystemCart. See Figure 6.50.3. Secure the System to the cart with the foursocket head screws in the Therapy SystemCart Top. See Figure 6.51.NOTE:Secure the System to the cart bytightening the screws by hand only. Donot use a wrench to tighten the screws.Overtightening may cause damage to theSystem or Module housing.4. Plug Power Cord into the System MainsDisconnect and reinstall the Rear AccessPanel. Install all lead wires and cables tothe System.5. Install Storage Bins into Therapy SystemCart. Start with bottom Storage Bin first.B. Dismounting Therapy System fromTherapy System Cart1. To remove the System from the TherapySystem Cart, repeat the Mounting Systemto Therapy System Cart instructions inreverse order.11.5 CM (4.5”)SYSTEM ONLY16.5 CM (6.5”)SYSTEM W/MODULEFIGURE 6.49FIGURE 6.50HAND TIGHTEN THE SOCKETHEAD SCREWS TO SECURESYSTEM TO CARTREMOVEALL BINSFIGURE 6.5178