RealView Debugger User Guide - ARM Information Center

Working with Breakpoints4.8 Using the Set Address/Data Breakpoint dialog boxThe Set Address/Data Breakpoint dialog box provides comprehensive facilities toenable you to specify new breakpoints of any type in full (see Breakpoint types onpage 4-2). You can also use it to edit existing breakpoints.This section describes how to use the Set Address/Data Breakpoint dialog box, andincludes:• Displaying the Set Address/Data Breakpoint dialog box• Editing an existing breakpoint on page 4-42• Set Address/Data Breakpoint dialog box interface components on page 4-42• Setting software breakpoints on page 4-45• Setting hardware breakpoints on page 4-46• HW Support settings for RVISS on page 4-47• HW Support settings for target hardware on page 4-48• HW Support settings for a DSP-based debug target on page 4-49• Using ranges and masks with hardware breakpoints on page 4-50• Specifying Qualifiers on page 4-52• Specifying Actions on page 4-53• Managing the qualifier and action lists on page 4-55.4.8.1 Displaying the Set Address/Data Breakpoint dialog boxTo display the Set Address/Data Breakpoint dialog box, shown in Figure 4-13 onpage 4-42, use one of the following methods:• Select Debug → Breakpoints → Set/Edit Breakpoint... from the Code windowmain menu.• Using the Break/Tracepoints pane, either:— select Set/Edit Breakpoint... from the Pane menu— right-click on the pane background, and select Set/Edit Breakpoint... fromthe context menu.• Right-click on the margin, an instruction, or line of source code in the File Editorpane, and select Set Break... from the context menu.• Right-click on an memory location in the memory pane, and select Set BreakAt... from the context menu.• Right-click on a value shown in the Watch pane, or on a variable shown in the CallStack pane, then select Break at... from the context menu.ARM DUI 0153G Copyright © 2002-2005 ARM Limited. All rights reserved. 4-41