RealView Debugger User Guide - ARM Information Center

Working with ImagesClosing auto-projectsTo close an auto-project, right-click on the Project entry in the Process tab andselect Close from the Project context menu. If you close the auto-project associatedwith a loaded image, this immediately unloads the image and removes all image detailsfrom the debugger. If you close an auto-project, RealView Debugger executes any closecommands associated with the project.NoteYou can also use the Project menu from the Code window main menu to closeauto-projects.See the chapter that describes working with multiple projects in RealView Debuggerv1.8 Project Management User Guide for more details on working with auto-projects.2.2.4 Working with user-defined projectsWith a user-defined project open, right-click on the Project entry to display the Projectcontext menu.This menu enables you to view details of your project, make changes to project settings,and to perform selected components of the build model following changes to projectfiles.See the description of the Project menu in the chapter that describes working withprojects in RealView Debugger v1.8 Project Management User Guide for full details onthese options.Closing user-defined projectsTo close a user-defined project where the associated image is loaded, right-click on theProject entry in the Process tab and select Close from the Project context menu.RealView Debugger gives you the option to unload the image when the project closes.If you choose to unload the image, RealView Debugger completes the operation, closesthe project, and then executes any close operations associated with the project.If you do not unload the image, the debugger:1. Closes the user-defined project.2. Executes any close commands associated with the project.ARM DUI 0153G Copyright © 2002-2005 ARM Limited. All rights reserved. 2-17