RealView Debugger User Guide - ARM Information Center

Workspace Settings ReferenceTable A-10 Edit settings (continued)NameNo_tooltipTimerTool_saveStartupTemplateRestore_statePropertiesBy default, tooltip evaluation of variables and registers is enabled.Change this setting to True to disable this feature.During file editing, the editor periodically checks to see if anothertool has edited or deleted the files being tested. A warning is shownif an update is detected.Use this to specify the number of seconds between checks. Thedefault is 60 seconds. Use values greater than 30 seconds. Set to -1 todisable this feature.When performing a build, you are prompted to resave any files thathave been edited. Use this to specify automatic resaving of changedfiles at build time to ensure that your latest sources are included. Youcan also set a no-save, no-ask value.The default start-up file, that is rvdebug.sav in your home directory,contains a list of previously edited files and information fromprevious debugging or editing sessions. This enables historicalinformation to be separated from your current session.Use this to specify a different start-up file, in a new location. Set thisto - (dash) to specify that no start-up file is used.During file editing, you can use templates to speed up codedevelopment. The template file contains templates that you can use oredit as required.By default, the file is named rvdebug.tpl and is saved in your homedirectory, or in the default settings directory \etc. Use this to changethis pathname.Not used.ARM DUI 0153G Copyright © 2002-2005 ARM Limited. All rights reserved. A-15