RealView Debugger User Guide - ARM Information Center

Working with Breakpoints4.3 Generic breakpoint operationsThe Debug → Breakpoints menu enables you to complete certain breakpointoperations that are common to all breakpoints:Toggle Break at CursorToggles a breakpoint at the address defined by the position of the cursorin your code view:• If no breakpoint exists at the address, a new default breakpoint iscreated (see Default breakpoints in the GUI on page 4-5).• If a breakpoint already exists at the address, it is cleared.Enable/Disable Break at CursorEnables or disables a breakpoint at the address defined by the position ofthe cursor in your code view:• If an enabled breakpoint already exists at the address, it is disabled.• If a disabled breakpoint already exists at the address, it is enabled.• If no breakpoint exists at the address, a new default breakpoint iscreated (see Default breakpoints in the GUI on page 4-5).Clear All Break/TracepointsClears all breakpoints, and tracepoints, that you have set on the currenttarget.See Disabling and clearing breakpoints on page 4-72 for more details of disabling andclearing breakpoints.4-20 Copyright © 2002-2005 ARM Limited. All rights reserved. ARM DUI 0153G