RealView Debugger User Guide - ARM Information Center

Working with MacrosFigure 9-3 Loading macros on connectionIf RealView Debugger cannot locate one of the specified files, it displays a message boxand gives you the option to abort the connection.For full details on how to specify these commands using the Connection Propertieswindow, see the chapter that describes how to configure custom connections inRealView Debugger v1.8 Target Configuration Guide.Loading macros from a projectYou can load one or more macros automatically when you open a project that binds toa connection. Do this by specifying the macros to be loaded using the Project Propertieswindow. Enter the calling command using the Open_conn setting in theCommand_Open_Close group, shown in Figure 9-4.Figure 9-4 Loading macros from a projectIf RealView Debugger cannot locate one of the specified files, it displays a messagebox. The project then opens and binds as normal.ARM DUI 0153G Copyright © 2002-2005 ARM Limited. All rights reserved. 9-15