RealView Debugger User Guide - ARM Information Center

Working with Images2.2 Managing imagesThis section describes how to manage your application files in the Code window. Itcontains the following sections:• Viewing image details in the Code window• Viewing image details in the Process Control pane on page 2-11• Working with auto-projects on page 2-13• Working with user-defined projects on page 2-17.The examples in this section assume that:• you are using a Typical installation and that the software has been installed in thedefault location. If you have changed these defaults, or set the environmentvariable RVDEBUG_INSTALL, your installation differs from that described here.• you are licensed to use multiprocessor debugging mode. However, where given,multiprocessor examples are only used for illustration. If you are licensed to workin single-processor mode your Code window differs from that shown here, forexample some toolbar buttons are not available to you, but all the examples workas described.2.2.1 Viewing image details in the Code windowIf an image is successfully loaded to the target processor, the Code window is updated,shown in Figure 2-3 on page 2-10.ARM DUI 0153G Copyright © 2002-2005 ARM Limited. All rights reserved. 2-9