RealView Debugger User Guide - ARM Information Center

Working with Browsers and Favorites8.9.4 Favorites categories used by RealView Debugger featuresTable 8-2 describes where each Favorites Category is used in RealView Debugger.Table 8-2 Favorites Categories used by RealView Debugger featuresFavorites CategoryAddressesData ValuesData EndsWhere it is used in RealView DebuggerThis is used where you can specify an address or an address range:• In the dialog boxes for setting breakpoints, where you wantto specify an address.See Chapter 4 Working with Breakpoints for details onusing the breakpoint dialog boxes.• In the dialog boxes for setting tracepoints, where you wantto specify an address or an address range.See the chapter the describes tracing in RealView Debuggerin the RealView Debugger v1.8 Extensions User Guide fordetails on using the tracepoint dialog boxes.• In the dialog boxes used to locate a specific address, such asin the:— Stack pane (see Using the Stack pane on page 6-31)— Memory pane (see Displaying memory contents onpage 6-19)— Dsm tab.Used to specify data values in the dialog boxes when setting:• BreakpointsSee Chapter 4 Working with Breakpoints for details onusing the breakpoint dialog boxes.• TracepointsSee the chapter the describes tracing in RealView Debuggerin the RealView Debugger v1.8 Extensions User Guide fordetails on using the tracepoint dialog boxes.• The value of a memory location in the Memory pane.See Displaying memory contents on page 6-19.• The value of a register in the Register pane.See Changing register contents on page 6-6.Used by the HW Break on Data Value match dialog box, to specifya data value modifier.See Using the HW Break on Data Value match dialog box onpage 4-29 for details.8-32 Copyright © 2002-2005 ARM Limited. All rights reserved. ARM DUI 0153G