RealView Debugger User Guide - ARM Information Center

Working with Debug Views3. Double-click on the Proc_5 function name.4. Click on the function name, and drag it to the PC register.The address of the Proc_5 function is loaded into the PC register, and the sourcelevel view changes to show the code for the Proc_5 function. The Dsm tab is alsoupdated.NoteIf the function code is in a different source file, and that source file is not open,RealView Debugger cannot determine the context, and informs you of this in theSrc tab. However, the Dsm tab is updated.Updating register contentsThe Register pane updates automatically when register contents change. This is set bydefault, as indicated by the checked option Automatic Update on the Pane menu.If you change this default option, you must update the pane display manually. SelectUpdate Window from the Register pane context menu to update the view. RealViewDebugger updates the pane contents and displays changed values in blue for improvedreadability.6.1.4 Viewing different registersThe Register pane displays tabs and registers appropriate to your:• target processor, that is different target processors contain different registers andso the contents of this pane change depending on the target you are debugging• target interface, for example RealView ICE• target configuration, for example if you are using a .bcd file, the pane includesextra tabs to provide extended target visibility.In Figure 6-3 on page 6-8, the Register pane shows registers for an ARM940T core andthe ARM Integrator /AP board using Multi-ICE.ARM DUI 0153G Copyright © 2002-2005 ARM Limited. All rights reserved. 6-7