RealView Debugger User Guide - ARM Information Center

Starting to use RealView Debugger1.2 Using RealView Connection BrokerTarget vehicles can reside on the same workstation as RealView Debugger or any otherworkstation on your network. These services are handled by RealView ConnectionBroker. This section includes:• RealView Connection Broker operating modes• Starting RealView Connection Broker on Windows• Starting RealView Connection Broker from the command line on page 1-9• Using RealView Network Broker on page 1-10.1.2.1 RealView Connection Broker operating modesRealView Connection Broker operates in two modes:LocalRemoteOperating as RealView Simulator Broker, this runs on your localworkstation and enables you to access targets on the local workstation.Operating as RealView Network Broker, this runs on a remoteworkstation and makes specified targets on that workstation available toother workstations connected to the same network.Local host simulators are available immediately from the Connection Control window.If you expand the Simulator Broker vehicle, ready to connect to a simulator, RealViewDebugger starts RealView Connection Broker in local mode to manage yourconnection.See the chapter that describes configuring custom connections in RealView Debuggerv1.8 Target Configuration Guide for examples of how to set up your own connections.1.2.2 Starting RealView Connection Broker on WindowsTo start RealView Connection Broker, select the following from the Windows Startmenu:Programs → ARM → RealView Developer Suite v2.2 → RealView NetworkBroker v1.8.1This starts RealView Connection Broker in remote mode.1-8 Copyright © 2002-2005 ARM Limited. All rights reserved. ARM DUI 0153G