RealView Debugger User Guide - ARM Information Center

Configuring Workspace Settings10.3 Configuring workspace settingsThe following notes apply to changing your workspace settings:• Settings are applied in the order they are shown in the settings hierarchy in the leftpane. This means that settings in the workspace file take priority over globalconfiguration settings if a conflict arises when you open a workspace.• If you edit the workspace settings, the .aws file is updated when you save thechange. This change takes effect in any new Code windows you open in thecurrent session.• Use the Options window to make changes to global configuration options savedin the rvdebug.ini file.• If you edit the global configuration options, the .ini file is updated when yousave the workspace file. This change takes effect when the workspace next opens.• Do not change the same setting in the Workspace Options window and theOptions window at the same time because the views might not be consistent.This section describes:• Restoring settings• Changing settings on page 10-16• Copying entries on page 10-17• Pasting entries on page 10-17• Cutting entries on page 10-19• Resetting entries on page 10-19.10.3.1 Restoring settingsIf you have made changes to your workspace settings file, or your global configurationfile, and you want to restore the factory settings:1. Exit RealView Debugger in the normal way.2. Locate the .aws and the .ini files in your RealView Debugger home directory.3. Delete both files.4. Start RealView Debugger and accept the option to create a new .aws file.ARM DUI 0153G Copyright © 2002-2005 ARM Limited. All rights reserved. 10-15