RealView Debugger User Guide - ARM Information Center

Reading and Writing Memory, Registers, and FlashFigure 7-2 Interactive Memory Setting dialog box12. Enter the required memory settings:Type: Select the display format. See Formatting options on page 6-21 fordetails of the memory formats.Addr: The address where the memory setting starts. Depending on themethod used to display this dialog box, this field is already populated,as in this example.The address must be entered in hexadecimal format, for example0x000088A0.Value: This read-only data field shows the current value, in hexadecimal anddecimal formats, at the specified memory location.Enter New Value:Enter the value to be set at the current location, for example 0x08 or 8(decimal).If the Memory pane is configured to update automatically, clicking Setimmediately updates the memory contents. This is the default settingin the Pane menu.If you press Enter with no value in the Value data field, RealViewDebugger moves automatically to the next, or previous, location.Next AddrMoves the target address to the next location by adding 1 to the addressdisplayed in the Addr data field. This depends on the size of the currenttype.ARM DUI 0153G Copyright © 2002-2005 ARM Limited. All rights reserved. 7-11