RealView Debugger User Guide - ARM Information Center

Configuring Workspace SettingsALLThese settings govern the behavior of the editor, the editor display, andaccess to source code. The settings in the ALL group are used inconjunction with the settings in the DEBUGGER group and the CODE groupand might be overridden by settings in either of these two groups.PROJECTSThis specifies a project load list, that is a project, or projects, openedwhen the debugger starts with this workspace or when you open thisworkspace in a session. This list includes user-defined projects and anyauto-projects where you have saved the settings.This group is created automatically when RealView Debugger closesdown with open projects, or if you close the current workspace.WINDOWThis is a special group of windows internals maintained by RealViewDebugger. An entry is created for each open window. Entries cannot beedited.You must not delete these entries.CONNECT When you close down, you have the option to save connection details sothat the same connections are used when RealView Debugger starts upwith the same workspace.This is a special group, to specify connections, maintained by RealViewDebugger. An entry is created for each connection. Entries cannot beedited.You must not delete these entries.For a full description of all the workspace settings you can change see Appendix AWorkspace Settings Reference.10-14 Copyright © 2002-2005 ARM Limited. All rights reserved. ARM DUI 0153G