RealView Debugger User Guide - ARM Information Center

Configuring Workspace SettingsSave As Workspace...Saves the current workspace to disk using a new name. This is useful ifyou have made changes since your debugging session began and want tosave this new setup in a new workspace. This displays a dialog box whereyou can specify the new filename, for example test_workspace.aws.The newly-specified workspace becomes the current workspace.Workspace Options...Displays the Workspace Options window where you can view the currentworkspace settings or make changes. See Viewing workspace settings onpage 10-9 and Configuring workspace settings on page 10-15 for moredetails.Save Settings on ExitSelected by default, this option saves selected user-configured settingsand the current workspace when you exit RealView Debugger. Thisenables you to start your next debugging session in the same state.If selected, settings are saved in your start-up file, using the .savextension by default, for use next time and the current workspace file isupdated.Same Workspace on StartupSelected by default, this option saves the current workspace pathname inyour .sav file so that the same workspace is used at the next start-up.You can unselect this option so that the current workspace is not openedby default when you next start RealView Debugger. Unless you specify aworkspace on the command line, RealView Debugger then runs withouta workspace.Close WorkspaceCloses the current workspace. After the workspace closes, RealViewDebugger displays a list box so you can close any open objects. SeeClosing workspaces on page 10-5 for more details.Recent WorkspacesDisplays the Recent Workspace menu that lists any previous workspacesthat you have saved. Select a workspace from this menu to use thoseworkspace setting.10-4 Copyright © 2002-2005 ARM Limited. All rights reserved. ARM DUI 0153G