RealView Debugger User Guide - ARM Information Center

Working with Debug ViewsGlobal formatting of all registersClick the Pane menu to select formatting options for all registers currently displayed.This applies formatting to all registers, except those registers that you have specificallyformatted on an individual basis. For example, you might want to display contents asvalues rather than enumerations, or to display values in decimal format. This changeapplies to all tabs in the Register pane.Use the option Copy Pane to take a snapshot of the top-level pane display. You can thencopy this, for example into a text editor, so that you can compare registers and values.For selected registersYou can change the display format for a single register while viewing other registers inthe default format. Right-click on a chosen register, for example R3, to display theRegister context menu.This menu enables you to change the format of the chosen register, to view theproperties, or to change the register contents, for example, select Increment to add oneto the current value. You can also select from a list of previously used values to updatethe current contents.The values of the FIQ, IRQ, STATE, and MODE fields of the CPSR register can be set usingnames that enumerate to numerical values. The options offered on this menu depend onthe register currently under the mouse pointer. Position your pointer over the MODE fieldvalue of the CPSR register, which is set to SVC by default, and then right-click to displaythe status register context menu.You can use this menu to change the register contents, or pick from a list of valuesappropriate to this register.Select Set Enumeration... to display the selection box shown in Figure 6-2.Figure 6-2 Setting enumeration valuesARM DUI 0153G Copyright © 2002-2005 ARM Limited. All rights reserved. 6-5