RealView Debugger User Guide - ARM Information Center

Starting to use RealView DebuggerSyntax of the rvdebug commandThe syntax for starting RealView Debugger at the command-line is as follows:rvdebug [-b|-cmd][-install=pathname][-user=name][-home[=]pathname][-aws=pathname|-aws=-][-init[=]connection [-exec[=]image_pathname]][-inc[=]pathname][-jou[=]pathname][-log[=]pathname][-stdiolog[=]pathname][-nologo]where:-awsRuns a RealView Debugger session with the specified workspace. Thisoverrides any workspace specification that was stored when the previoussession ended.Use -aws=- to start without a workspace.-b Runs a RealView Debugger session in batch mode, that is without anyuser interaction.Use this with -inc to run a script file containing commands.Can be replaced with -b.NoteDo not use -b without -inc. If you do, RealView Debugger runs as ahidden process, and you have to use the Task Manager to terminate thervdebug process on Windows, or kill the rvdebug process on Sun Solarisor Red Hat Linux.If you use only -inc , the script file is run with the GUI enabled.-cmd-execRuns the RealView Debugger in headless debugger mode, where you canuse CLI commands to carry out debugging tasks. This enables you tointeract with the debugger without using the RealView Debugger GUI.See the RealView Debugger v1.8 Essentials Guide for details on gettingstarted with the headless debugger. Also, see the RealView Debugger v1.8Command Line Reference Guide for details on the CLI commands.Specifies the image to be loaded when RealView Debugger runs. Theimage specification can also include section details and image arguments.You can optionally include =, for example -exec=image.NoteYou must also use -init when loading an image in this way.ARM DUI 0153G Copyright © 2002-2005 ARM Limited. All rights reserved. 1-3