RealView Debugger User Guide - ARM Information Center

Working with ImagesChanging project settingsYou can change load settings for an image where you do not have a user-defined projectby defining actions in the auto-project and then the saving the file for use next time theimage loads. You can specify commands to execute when the project opens and/orcloses, or runtime controls that define the image environment.NoteChanging auto-project settings might not take effect until the next time the image isloaded and executed. Reload an image to implement any new settings.You can change settings for the in-memory auto-project in the same way as for auser-defined project:1. Right-click on the Project entry, to display the Project context menu.2. Select Project Properties... to display the Project Properties window.3. Expand the PROJECT group to see the project settings, shown in Figure 2-6.Figure 2-6 Changing auto-project settingsHere you can see the Command_Open_Close group and other project settings.4. Expand the SETTINGS group to see the image settings.Figure 2-6 shows the Image_load group and other image settings, such asbreakpoints and runtime controls.5. Right-click on the Image_load group and select Explore to see the group contentsin the right pane.6. Right-click on the Set_pc entry and select never from the options.ARM DUI 0153G Copyright © 2002-2005 ARM Limited. All rights reserved. 2-15