AlphaCom XE - Zenitel

More documents

Recommendations

Info

AlphaCom XE7 AlphaCom XE7 AlphaCom XE7AlphaCom XE7AlphaCom XE7AlphaCom XE7 AlphaCom XE7 AlphaCom XE7AlphaCom XE7VMP-D619# *1 2 3 4 5 STENTOFON1 2 34 5 67 8 9M 0 CVINGTORAlphaCom XE7VMP-D619# *1 2 3 4 5 STENTOFON1 2 34 5 67 8 9M 0 CVINGTORAlphaCom XE7AlphaCom XE7IPAll features available over the networkConsistent features and services across the enterprise regardless oflocation enhances user friendliness.AlphaCom XE provides all current AlphaNet features available today,including the enhanced features of LAN/WAN connection.VoIP, digital and analog infrastructure supportAlphaNet works over any infrastructure, whether it is IP, digital oranalog.RS232SIP client interfaceAlphaNet provides integration with GSM, analog, ISDN and DECTtelephones via SIP gateways. Most system functions are availablebetween the telephones and intercom stations.6.2 VoIP AlphaNet Configuration6.2.1 OverviewSee the Network Design Guide A100K10313 for more information.The following procedure is required when configuring AlphaNet:●●●●●●●●●●Insert AlphaNet license if VoIP AlphaNet should be usedCreate all the exchanges in the AlphaNetCreate AlphaNet data routingCreate AlphaNet audio routesUpdate the directory6.2.2 Insert AlphaNet licenseThis must be done if VoIP AlphaNet should be used (see section 3.3).6.2.3 Create all the exchanges in the AlphaNetDefine the exchanges in AlphaPro under Network & Exchanges. Seesection 4.3 on how to create the exchanges.LLIn some cases, it is not desired to program all the exchangesin the AlphaNet in the same AlphaPro database. In this caseyou should add the exchange in the network but un-tick thecheckbox for ‘AlphaNet - Adm. Here’.6.2.4 Create AlphaNet data routingAlphaNet link between AlphaCom XE servers●●●●●●●●●●Select the AlphaCom XE server in AlphaProClick the Exchange & System iconClick Net RoutingClick InsertSelect the destination AlphaCom node for the AlphaNet36 AlphaCom XE - Installation, Configuration & OperationA100K10805
Configure primary route●●●●●●●●●●●●Select Data on IP as ACDP LinkSelect node number for both Data and AudioTick the Audio on IP checkbox if a VoIP audio link shall be usedOption: Configure an alternative routeThe Preferred codec should be set to Best AvailableClick OKAlphaNet link to traditional AlphaCom servers●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●Select the AlphaCom serverClick the Exchange & System iconClick Serial PortsSelect a free ACDP Link (AlphaCom Data Protocol)Click ChangeTick the Enabled checkbox to enable the port and select the serialport for AlphaNet from the Port Type drop-down list.Set Link Type as Stentofon Link Layer – AlphaNetClick OK and close the serial port windowSelect Net RoutingClick InsertSelect the remote AlphaCom node for the AlphaNetConfigure the primary routeSelect the ACDP Link that was configured for AlphaNetSelect the Node Number for both Data and AudioDo NOT tick the Audio on IP checkboxOption: Configure an alternative routeClick OKLLFor each AlphaCom, it is required to configure AlphaNet linksto the AlphaComs that it communicates with.A100K10805AlphaCom XE - Installation, Configuration & Operation37
Page 1: AlphaCom XEInstallation, Configurat
Page 11 and 12: ●●●●The optional program co
Page 13 and 14: Hot-PlugAMC board statusSyncronisat
Page 15 and 16: 24 V48 VLine feedvoltage600 OhmComp
Page 17 and 18: 2.3 Performing a Cold StartA cold s
Page 19 and 20: STANDARD MESSAGES (VOICE/DISPLAY)AB
Page 21 and 22: MLH/CRM STATIONS ONLYCall request 6
Page 23 and 24: ●●The user will be prompted for
Page 25 and 26: LL●●Click Save to save the valu
Page 27 and 28: 4.1.3 PC requirements●●●●
Page 29 and 30: Exchange● ● In the main window,
Page 31 and 32: Exchange& SystemDirectoryNumbersExc
Page 33 and 34: --The text should normally be the s
Page 35: AlphaCom XE7AlphaCom XE7AlphaCom XE
Page 39 and 40: Stations in these nodes can be give
Page 41 and 42: 7 Multi-Module Network7.1 OverviewI
Page 43 and 44: AlphaCom XE7Alp ha Co m XE78 Extern
Page 45 and 46: 8.4.3 Create Prefix numberThe direc
Page 47 and 48: 9 Audio MessagingThe Audio Messagin
Page 49 and 50: The ASVP board has the same set of
Page 51 and 52: 9.2.2 Record message from a station
Page 53 and 54: --9101: Recall to global group 1 (f
Page 55 and 56: 9.4.1 ConfigurationThe default dire
Page 57 and 58: 10 System Monitoring10.1 System Log
Page 59 and 60: View log●●●●●●●●Log
Page 61 and 62: 11 Upgrade & BackupIt is necessary
Page 63 and 64: AC- DC-GND GND12.2 Physical Numbers
Page 65 and 66: S200 settingsThe switch S200 determ
Page 67 and 68: 12.5.1 RIO controller unit connecti

AlphaCom XE - Zenitel

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?