AlphaCom XE - Zenitel

S200 settingsThe switch S200 determines the Ethernet port speed, the duplex mode,and the link status LED mode.Link LEDEth 1Dual LEDLink LEDEth 0Dual LED~AMC IP11 boardSPEED / DUPLEXS200-1/2 S200-3/4 S200-5/6 Speed Duplex*OFF OFF OFF 10 Mbps HalfOFF OFF ON 10 Mbps FullOFF ON OFF 100 Mbps HalfOFF ON ON 100 Mbps FullON OFF OFF Auto HalfON OFF ON 10 Mbps AutoON ON OFF 100 Mbps AutoON ON ON Auto Auto* Full = Open duplex (telephone)Half = Voice controlled duplexAuto = Automatically sensedLINK STATUS FOR ETHERNET PORT 0 AND 1S200 Link LED Dual LED7 8 Off Green Off Green Red AmberOFF OFF !0 Mbps 100 Mbps Link down Half Duplex Error Full DuplexOFF ON Link down Link up No activity Rx activity Tx activity Tx+Rx act.ON OFF 10 Mbps 100 Mbps Link downON ON 10 Mbps 100 Mbps Link down* Blink rate = 100 msLink up,Activity*Link up,MII isolation*Full Duplex,Collisions*Full Duplex,Collisions*Link up infull DuplexLink up infull Duplex12.5 Port Pin-OutThe AlphaCom XE servers have two serial and two Ethernet ports.AlphaCom XE20/XE26For AlphaCom XE20 and XE26, the serial ports are available as RJ45connectors on the AMC-IP Filter Card.●●●●Serial Port 0 is set to RS232 only.Serial Port 1 is set to RS232 by default, but can be set to RS422 orRS485.--To set Serial Port 1 to RS422, set DIP switch S601-8 on the AMC-IP board to the ON position (see figure on page 64).--To set Serial Port 1 to RS485, set DIP switch S601-8 on the AMC-IP board to the ON postion, as well as move the two jumpers on theAMC-IP Filter Card to the “RS485” position.A100K10805AlphaCom XE - Installation, Configuration & Operation65