AlphaCom XE - Zenitel

If parameter 2 = 544 (i.e. 512+32), there will be no need to press theM-key to record and the message is dispatched when pressing theC-key. This option can be useful when using the recall function fromtelephones.1. Dial the recall number (e.g. 9084)2. Record message (no M-key)3. Press the C-key or hang up to dispatch the message or:--Press 7 (or #) to stop the recording and listen to the message--Press the M-key (or *) to restart a recording--Press 0 to delete the recording and cancel the operationFor two-step recall (i.e. 765 + group), the attributes are set in parameter1 (ID) of the 765 feature code.9.3.4 Simultaneous recall operationsSimultaneous recall operations are handled in the same way as forregular group calls.Several recall operations can be active at the same time as long asthere is no overlap in members of the simultaneous groups. If there isan overlap, the second recall operation will meet a busy signal.There is a “Max Missing Members” setting per group in AlphaPro, whichwill let the second group call go through if the overlap is less than thenumber of stations specified.Disable simultaneous group calls in AlphaPro●●Select Exchange & System > System > Calls and Options●●Disable Simultaneous Group Calls by unticking the checkbox--only one group call can be active at a timeEach group call can be assigned one out of four available SetupPriority levels.With Simultaneous Group Calls●●A group call is canceled by a group call with higher priority if there isoverlap between members.Without Simultaneous Group Calls●●An ongoing group call is canceled by a group call with higher priority.9.3.5 Hardware and software requirements●●Hardware: The recall function can be used on AMC-IP boardversions 10 and 11 (red or black PCB).●●Software: Recall is available from AMC software version 11●●License: Recall requires an Audio Messaging license.9.4 Auto-attendantThe Auto-attendant feature provides voice guided menus for handlingincoming calls.● ● Play a welcome message on incoming telephone calls● ● Press a digit to re-route the call● ● If no digits are pressed, the call will be automatically re-routed 5seconds after the message has finished playingThe auto-attendant feature is also available for internal calls and is notrestricted to external calls only.54 AlphaCom XE - Installation, Configuration & OperationA100K10805