apple-pascal-1.3-manual

This section describes the Pascal disks and files.System Disks-As SuppliedAPPLEO: contains all the files needed to edit and run Pascal programs,especially on a one-drive system; it includes SYSTEM.COMPILER, but notSYSTEM.APPLE, which is needed to start up the system. This is the secondof two disks used for a two-stage boot on a one-drive system.APPLEl: contains all the files you need to edit text and to start up thesystem. It is used in conjunction with the APPLE2: disk to compile or runPascal programs.APPLE2: contains the Compiler, Linker, Assembler, and other programdevelopment tools. It is used for program development.APPLE3: contains SYSTEM.APPLE, the Formatter program, several otherutility programs, a few demonstration programs for the general user, andthe 128K.APPLE and 128K.PASCAL files needed to use additional memory.It also contains the .MISCINFO files needed for use on an Apple II or II Plus.This is the first of two disks used for a two-stage boot. To learn about thethe demonstration programs on APPLE3:, consult Appendix 2F of Part II.IP AS CAL: contains all the files found on all four of the other system disks.It is the only 3Y:i-inch system disk and performs all Pascal 1.3 functions. It isphysically smaller than the other disks, though it holds 1600 blocks and canbe used to store textfiles and codefiles as well as system files.The following table lists the names of the files on each of the Pascal systemdisks. The order of the files on any disk is unimportant. The Filer'sList-directory command will display the exact length of each file for you.See Appendix 2B for approximate block lengths.APPLEO: APPLEl: APPLE2:SYSTEM.PASCAL SYSTEM.APPLE SYSTEM.ASSMBLERSYSTEM.COMPILER SYSTEM.PASCAL SYSTEM.COMPILERSYSTEM.EDITOR SYSTEM.EDITOR SYSTEM.LINKERSYSTEM.FILER SYSTEM.FILER LIBRARY.CODESYSTEM.LIBRARY SYSTEM.LIBRARY LIBMAP.CODESYSTEM.MISCINFO SYSTEM.MISCINFO 6502.0PCODESSYSTEM.CHARSET SYSTEM.CHARSET 6502.ERRORSSYSTEM.SYNTAX SYSTEM.SYNTAXApple Pascal System Disks and Files 1-31