i agree and wish to proceed with download - Roland Systems Group ...

Effect typesReverbSt.REVERB (Stereo Reverb)fig.AlgoStRev.epsInput LDRYOutput LValue: -36.0–0.0 dBLO FREQ DAMP FREQFrequency at which the low-frequency region of the reverb soundbegins to be attenuatedValue: 20 Hz–2.00 kHzHI FREQ DAMP GAINStereoReverb4 Band EQHigh-frequency attenuation of the reverb soundValue: -36.0–0.0 dBHI FREQ DAMP FREQInput RDRYOutput RThis is a stereo-in, stereo-out reverb. It adds reverberation withoutimpairing the position of the sound image that’s been set for thestereo input, by panning or other means.ReverbTYPEFrequency at which the high-frequency region of the reverb soundbegins to be attenuatedValue: 200 Hz–20.00 kHzHI CUT FREQFrequency at which the high-frequency region of the reverb soundwill be cutValue: 200 Hz–20.00 kHzType of reverbValueROOM1: Typical room reverbROOM2: Room reverb with a softer tone than ROOM1HALL1: Typical hall reverbHALL2: Hall reverb with a softer tone than HALL1PLATE: Plate reverbSIZE (Room size)Size of the room or hallValue: 5–40 mTIME (Reverb time)Length of the reverberationValue: 0.1–32.0 sPreDly (Pre-delay time)Time until the reverb is heardValue: 0–200 msER Lev (Early reflection level)Level of the early reflectionsValue: -INF–0.0 dBDiffus (Diffusion)Amount of scattering for the early reflectionsValue: 0–100DensityDensity of the reverb soundValue: 0–100WET (Wet Level)Level of the reverb soundValue: -INF–+6.0 dBDRY (Dry Level)Level of the original soundValue: -INF–+6.0 dBBAL (Balance)L/R output level balance of the reverbValue: L63-C-R63EQEQ SW (EQ switch)Turns the EQ on/offValue: OFF, ONEQ ATT (EQ attenuator)Attenuator for the EQValue: -42.0–+6.0 dBLOW TYPEFilter type for the Lo band (*1)Value: PEAK, LSV, HSV, LPF1, HPF1, LPF2, HPF2, BPF,BEF, THRULO GAINGain of the Lo band (*1)Value: -15.0–+15.0 dBAppendixLO FREQ DAMP GAINLow-frequency attenuation of the reverb soundLO FREQCenter frequency of the Lo band (*1)Value: 20 Hz–20.00 kHz217