i agree and wish to proceed with download - Roland Systems Group ...

AUX channel and MAIN L/R channel operationsSending the audio signal to aMATRIX busThis operation is performed in the AUX SENDS area of theCHANNEL EDIT section.fig.ChEdtAux.epsOperations in the CHANNELDISPLAY screenThe principal parameters of the MAIN L/R channels and AUXchannels can be operated in the CHANNEL DISPLAY screen.CHANNEL DISPLAY screenAUX channel and MAIN L/R channel operations1. Press AUX SELECT [1]–[8] to select the send-destinationMATRIX bus.2. Use the SEND LEVEL knob to adjust the amount of signalsent to the MATRIX bus.fig.ScrChMainGuide.eps23fig.ScrChAuxGuide.eps1 4 7 95681011You can make fine adjustments by holding down [SHIFT] whileyou operate the knob.You can’t use SENDS ON FADER to adjust the send amount toan MATRIX bus.By pressing [DISP] you can access the MATRIX SENDS popupwhere you can make detailed MATRIX send settings.1. Attenuatorfig.ScrMtxATTGuide.epsbaFor the MAIN L/R channel, use [F7 ( MTX SENDS)] or[F7 ( AUX SENDS)] to switch the CHANNEL DISPLAY screenbetween the MTX SENDS display and the AUX SENDS display.The target of operations in the CHANNEL EDIT section’s AUXSENDS area will also follow the CHANNEL DISPLAY screen.For the MAIN L/R channel, operations in the AUX SENDS areaare valid only while the CHANNEL DISPLAY screen is shown.a. ATT knobThis adjusts the channel’s input level in the range of -48 dB–0dB (6 dB steps).b. OL (Overload) indicatorThis will light red when the output of the attenuator exceeds theOVER Lev setting specified in the METER SETUP popup (p. 96).58