SP60 Series - X-Rite

SETTING INSTRUMENT CONFIGURATION4.6.2 Read OperationTo access the Read Operation Options:1. Use the Tab keys $@ to highlight Read Oper..Hardware SettingsSerial Port :9600Read Oper. :SwitchCal Timeout :24 hrsPower Down :120 secBeeper :Soft↓2. Press the Enter # key to access the Read Operationoptions.3. Use the Tab keys $@ to highlight the desired read operationmode: RCI Only, Switch Only, Key Only, orSwitch and Key. Press the Enter # key to save yoursetting and return to the Hardware Settings Options menu.4.6.3 Cal TimeoutTo access the Cal Interval Setup:1. Use the Tab keys $@ to highlight Cal Timeout.Hardware SettingsSerial Port :9600Read Oper. :SwitchCal Timeout :24 hrsPower Down :120 secBeeper :Soft↓2. Press the Enter # key to open the Set Cal Intervalmenu.Set Cal IntervalCLEAR↓24↑OnSave & Exit3. Use the Tab keys $@ to choose the desired cal interval digit(arrows above and below designate selection). Press theEnter key # to access the alphanumeric editor.NOTE: Highlighting CLEAR and pressing the Enter key # is a quickmethod to zero the value.4. Use the Tab keys $@ to highlight the desired number andpress the Enter # key to exit the editor. If desired, changethe cal interval status from On to Off.4-19