Panasonic Air Conditioner

More documents

Recommendations

Info

8.8. Wireless Remote Control Name and function of each part Transmitter Transmits the remote control signal. <strong>Air</strong>flow direction setting display Fan speed display Temperature setting display (16°C - 31°C) Time/time setting display Shows the timer operation setting time or the current time. NOTES • Ensure that the correct button is pressed as simultaneous pressing of the multiple buttons will not make the setting correct. • The illustration above is for explanatory purpose only. The appearance will be different during actual operation. • If using the wireless remote control in conjunction with the wired remote control, the settings made from the wireless remote control will appear on the wired remote control display (except when making timer settings). • Buttons marked with * are not needed for normal operation. If one of these buttons is pressed by mistake, press the same button once more to cancel the operation. • When the power resumed after power failure, the unit will restart automatically with all previous settings preserved by the memory function. (Auto restart function) 24 Address number display Operation selection display OFF/ON button Used to start and stop the operation. ODOUR WASH button FILTER RESET button Press to cancel the “FILTER” indicator light on the control panel. FAN SPEED button Used to select the fan speed of high (HI), medium (MED), low (LO) or auto (AUTO). SET button* Local setting function. ADDRESS SET button* Used to change the address setting when using more than one indoor unit. RESET button Pressing this button will clear all the settings from memory. You will then need to make the settings again. TIMER/CLOCK SET buttons Used to set the timer operation and the current time. AIR SWING (AUTO/MANUAL) buttons Used to determine the air swing condition, either auto or manual. MODE button Used to select the operation of AUTO, FAN, COOL or DRY. TEMP (UP/DOWN) buttons Used to select the desired temperature. ECONOMY operation button
9 Operation Details 9.1. Cooling Operation • Cooling operation can be set using remote control. • This operation is applied to cool down the room temperature reaches the setting temperature set on the remote control. • Cooling Operation Time Diagram. 9.2. Soft Dry Operation • Soft Dry Operation can be set using remote control. • Soft Dry operation is applied to dehumidify the room. • When operation begins, the fan speed is fixed at Low speed while cooling operation is running until reaches the remote control setting temperature. 9.3. Auto Operation • Automatic Mode can be set using remote control. • This operation starts to judge the intake air temperature, setting temperature, and outdoor piping temperature. Then the unit starts to operate at determined operation mode. 9.4. Fan Operation • Fan operation can be set using remote control. • The indoor fan is operated at High, Medium or Low speed according to remote control setting. 25
Page 1 and 2: TABLE OF CONTENTS 1 Service Informa
Page 3 and 4: 1 Service Information The new Casse
Page 5 and 6: 2 Features 2.1. Ceiling Type 2.1.1.
Page 7 and 8: 2.3. Wired Remote Control 1. The ne
Page 9 and 10: 3 Product Specification 3.1. CS-F18
Page 11 and 12: 4 Dimensions 4.1. CS-F18DTE5 11
Page 13 and 14: 5 Refrigeration Cycle 5.1. CS-F18DT
Page 15 and 16: 7 Wiring Diagram 7.1. CS-F18DTE5 15
Page 17 and 18: 8 Operation Instructions 8.1. Wired
Page 19 and 20: 8.3. Remote Control - Panel 19
Page 21 and 22: CLOCK Display (To set current Day a
Page 23: For example , if you want to set: A
Page 27 and 28: 9.6. Operation Control 9.6.1. Odour
Page 29 and 30: 9.7.7. Sensor Disconnection Detecti
Page 31 and 32: 10.3. Position of the centre gravit
Page 33 and 34: The unit must be installed in accor
Page 35 and 36: 1. Open the inlet grille, and remov
Page 37 and 38: 10.4.5. Indoor unit drain piping
Page 39 and 40: CONNECTING THE WIRES TO THE CONTROL
Page 41 and 42: 10.4.11. Check the following items
Page 43 and 44: The unit must be installed in accor
Page 45 and 46: 4. Refrigerant filling Refrigerant
Page 47 and 48: 10.5.5. Transporting and installing
Page 49 and 50: 10.5.7. Heat insulation 10.5.8. Cha
Page 51 and 52: • Power supply specifications Mod
Page 53 and 54: 10.5.12. As to making the inspectio
Page 55 and 56: Remote controller wiring • Connec
Page 57 and 58: If remote control cable is embedded
Page 59 and 60: Automatic address resetting for gro
Page 61 and 62: Example of previous problem display
Page 63 and 64: Wireless remote control installatio
Page 65 and 66: Receptor unit (for ceiling type) as
Page 67 and 68: NOTE • If the batteries are repla
Page 69 and 70: 11 Installation and Servicing Air C
Page 71 and 72: 11.2.2. R410A tools 1. Copper tube
Page 73 and 74: 8. Electronic scale for refrigerant
Page 75 and 76:
Nominal diameter Outside diameter (
Page 77 and 78:
11.4.2. Transferring (Using new ref
Page 79 and 80:
11.4.6. Brazing As brazing requires
Page 81 and 82:
(When remote control display shows
Page 83 and 84:
12.3. Test operation and self-diagn
Page 85 and 86:
12.3.4. Self-diagnosis function The
Page 87 and 88:
12.4. Emergency operation When usin
Page 89 and 90:
12.5. Self-diagnosis error code tab
Page 91 and 92:
13 Technical Data 13.1. Cooling cap
Page 93 and 94:
Model Cooling capacities are based
Page 95 and 96:
13.3. Reaching distance • CS-F18D
Page 97 and 98:
13.5. Sound measuring point 13.5.1.
Page 99 and 100:
13.7. Discharge and suction pressur
Page 101 and 102:
14.2. CS-F18DTE5 101
Page 103 and 104:
15 Replacement Part List (Indoor Un
Page 105 and 106:
16 Exploded View (Outdoor Unit) 16.
Page 107 and 108:
17 Replacement Part List (Outdoor U
Page 109:
18.2. Indoor Unit Printed (Indicato
show all

Panasonic Air Conditioner

Create successful ePaper yourself

Delete template?

Save as template?