Panasonic Air Conditioner

More documents

Recommendations

Info

10.6.5. Test operation • Turn on the main power. • After 3 minutes have passed since the power was turned on, press the OFF/ON switch on the remote controller. (No operation occurs within 3 minutes after the power was turned on.) • Press the TEST RUN switch within 1 minute of pressing the OFF/ON switch. • Next, select the operation mode. (Be sure to select cooling mode first, and run the unit in this mode for 5 minutes or more.) • Press the OFF/ON switch or the TEST RUN switch to cancel test operation. • Test operation will be cancelled automatically after 30 minutes. • Check once more that the remote control cable is securely connected. (Check for loose terminals, poor contacts, connection positions terminal block, etc.) • If the above checks show that nothing is wrong but nothing appears on the remote controller display. • It is possible that the remote controller was connected while the main power was still turned on. If such is the case, carry out the following. • Set DIP switch (SW2) No. 1 to 4. The ON position, and then turn on the main power. If the display appears after about 30 seconds, turn DIP switches 2 to 4 to OFF position. 10.6.6. Self-diagnosis function If remote controller displays nothing If “CHECK” is blinking on the timer • If the “CHECK” display on the wired remote controller is blinking, the details of the problems are displayed on the timer display screen each time the CHECK switch is pressed. • Further details of the problem can be displayed by pressing the SET switch while the general problem details are being displayed. Example of current problem display If “CHECK” is not blinking on the timer • If the “CHECK” display on the wired remote controller is not blinking, press the CHECK switch continuously for 5 seconds or more to display the problem details for the last problem or the problem before that. • You can then switch between the display for the previous problem and the problem before that by pressing the UP (TIMER) DOWN (TIMER) switches. • Press the CHECK switch once more to return to the normal display. 60
Example of previous problem display Example of abnormality display before previous display • The display can be switched between the previous problem and the one before that by pressing the UP (TIMER) DOWN (TIMER) switches. • After eliminating the cause of the problem, press the CHECK switch once more to return to the normal display. 61
Page 1 and 2:
TABLE OF CONTENTS 1 Service Informa
Page 3 and 4:
1 Service Information The new Casse
Page 5 and 6:
2 Features 2.1. Ceiling Type 2.1.1.
Page 7 and 8:
2.3. Wired Remote Control 1. The ne
Page 9 and 10: 3 Product Specification 3.1. CS-F18
Page 11 and 12: 4 Dimensions 4.1. CS-F18DTE5 11
Page 13 and 14: 5 Refrigeration Cycle 5.1. CS-F18DT
Page 15 and 16: 7 Wiring Diagram 7.1. CS-F18DTE5 15
Page 17 and 18: 8 Operation Instructions 8.1. Wired
Page 19 and 20: 8.3. Remote Control - Panel 19
Page 21 and 22: CLOCK Display (To set current Day a
Page 23 and 24: For example , if you want to set: A
Page 25 and 26: 9 Operation Details 9.1. Cooling Op
Page 27 and 28: 9.6. Operation Control 9.6.1. Odour
Page 29 and 30: 9.7.7. Sensor Disconnection Detecti
Page 31 and 32: 10.3. Position of the centre gravit
Page 33 and 34: The unit must be installed in accor
Page 35 and 36: 1. Open the inlet grille, and remov
Page 37 and 38: 10.4.5. Indoor unit drain piping
Page 39 and 40: CONNECTING THE WIRES TO THE CONTROL
Page 41 and 42: 10.4.11. Check the following items
Page 43 and 44: The unit must be installed in accor
Page 45 and 46: 4. Refrigerant filling Refrigerant
Page 47 and 48: 10.5.5. Transporting and installing
Page 49 and 50: 10.5.7. Heat insulation 10.5.8. Cha
Page 51 and 52: • Power supply specifications Mod
Page 53 and 54: 10.5.12. As to making the inspectio
Page 55 and 56: Remote controller wiring • Connec
Page 57 and 58: If remote control cable is embedded
Page 59: Automatic address resetting for gro
Page 63 and 64: Wireless remote control installatio
Page 65 and 66: Receptor unit (for ceiling type) as
Page 67 and 68: NOTE • If the batteries are repla
Page 69 and 70: 11 Installation and Servicing Air C
Page 71 and 72: 11.2.2. R410A tools 1. Copper tube
Page 73 and 74: 8. Electronic scale for refrigerant
Page 75 and 76: Nominal diameter Outside diameter (
Page 77 and 78: 11.4.2. Transferring (Using new ref
Page 79 and 80: 11.4.6. Brazing As brazing requires
Page 81 and 82: (When remote control display shows
Page 83 and 84: 12.3. Test operation and self-diagn
Page 85 and 86: 12.3.4. Self-diagnosis function The
Page 87 and 88: 12.4. Emergency operation When usin
Page 89 and 90: 12.5. Self-diagnosis error code tab
Page 91 and 92: 13 Technical Data 13.1. Cooling cap
Page 93 and 94: Model Cooling capacities are based
Page 95 and 96: 13.3. Reaching distance • CS-F18D
Page 97 and 98: 13.5. Sound measuring point 13.5.1.
Page 99 and 100: 13.7. Discharge and suction pressur
Page 101 and 102: 14.2. CS-F18DTE5 101
Page 103 and 104: 15 Replacement Part List (Indoor Un
Page 105 and 106: 16 Exploded View (Outdoor Unit) 16.
Page 107 and 108: 17 Replacement Part List (Outdoor U
Page 109: 18.2. Indoor Unit Printed (Indicato
show all

Panasonic Air Conditioner

Create successful ePaper yourself

Delete template?

Save as template?