Panasonic Air Conditioner
Panasonic Air Conditioner
Panasonic Air Conditioner
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
NOTE<br />
• If the batteries are replaced or the remote controller is reset, the address setting will return to ADDRESS1, so you will need to<br />
repeat the address setting again.<br />
All setting details which are stored in memory will be cleared, so you will need to repeat the setting.<br />
• If the address is set to GROUP, more than one indoor unit can be operated at the same time.<br />
Example: If the address numbers for all indoor units are changed, other indoor units may operate accidentally due to signal interference.<br />
Control using two remote controllers<br />
• If both the wireless remote controller and the optional wired remote controller are being used together, either remote controller<br />
can be used to operate the indoor units.<br />
• The optional wired remote controller can be connected to only one other indoor unit besides the one with the receptor unit.<br />
• Two wireless remote controller cannot be connected at the same time.<br />
• When using the wireless remote controller and the optional wired remote controller, the MASTER/SLAVE setting is not needed.<br />
Group control<br />
• When using group control, be sure to install the receptor unit to indoor unit No. 1. (Refer to the illustration below.)<br />
• When using group control, up to a maximum of 16 indoor units can be connected. (Do not mix heat pump units and cooling only<br />
units.)<br />
• When using group control, the indoor unit address numbers can be set automatically. However, you will not know at this time<br />
which address number corresponds to which indoor unit.<br />
• Setting of address numbers can be carried out manually using the DIP switches. Manual settings have priority. (Do not combine<br />
both manual settings and automatic settings.)<br />
67