Panasonic Air Conditioner
Panasonic Air Conditioner
Panasonic Air Conditioner
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Automatic address resetting for group control<br />
• The address settings for group control (air conditioner Nos. 1 to 16) can be reset automatically.<br />
1. When operation is stopped, press for 5 seconds, continue the TEST RUN switch to display “00” (will be LOCAL MODE).<br />
2. Press the UP (TEMP) DOWN (TEMP) switch to display 10.<br />
3. Press the SELECT switch to display “000”. It would blink.<br />
4. Press the UP (TIMER) DOWN (TIMER) switch to display “001”. It would blink.<br />
5. Press the SET switch.<br />
Switching the thermistor<br />
• The temperature detection thermistor can be switched between the thermistor at the indoor unit and the thermistor at the remote<br />
controller. However, do not switch to the remote controller thermistor if using two remote controllers.<br />
1. When operation is stopped, press for 5 seconds, continue the TEST RUN switch to display “00” (will be LOCAL MODE).<br />
2. Press the UP (TEMP) DOWN (TEMP) switch to display 11.<br />
3. Press the SELECT switch to display “000”. It would blink.<br />
4. Press the UP (TIMER) DOWN (TIMER) switch to choose display “000” or “001”.<br />
“000”... Indoor unit setting (factory default)<br />
“001”... Remote controller setting<br />
5. Press the SET switch. (Be sure to press the SET switch so that normal operation mode can be resumed.)<br />
• Repeat the procedure in steps (1) to (5) to change the setting again.<br />
59
Change language