UC4™ Total Control™ Automatic Boom Height Technical ... - Norac

detailed description of the SENSOR DISPLAY and SETUP menus, refer
to Section 7 on page 22.
4.5.3 The " +/- " switch
Use the " +/- " toggle switch to change various settings in each of the
SETUP and SENSOR DISPLAY menus. Use the " +/- " switch to
increment/decrement numerical entries. If the switch is held, the number
will continue to automatically increase/decrease. If the selections for the
menu item are to be picked from a list, this switch will present the next
selection in the list. When in AUTOMATIC (AUTO) mode, use this
switch to modify the control height set point.
Not all menus allow the operator to change the setting with the " +/- "
switch. Some menus are only for informational purposes. In a menu where
a setting cannot be changed, the " +/- " switch is ignored.
4.5.4 AUTO (YES) /MANUAL switch
The UC4 boom control system has two operational modes –
AUTOMATIC (AUTO) and MANUAL. This toggle switch changes the
operational mode of the system. In AUTOMATIC (AUTO) mode, the
control panel will regulate the height of each boom to a predetermined set
point. In MANUAL mode, the sprayer functions as if no automatic control
system is present.
When the system is in AUTO, the operator can override automatic control
by operating the manual switches on the sprayer's boom controls (usually a
joystick or multifunction handgrip).
The "AUTO (YES)" switch also provides the alternate function "YES". In
some instances the control panel may prompt the operator with a question
that requires a yes or no response.
4.5.5 POWER switch
The power switch is located on the left side of the control panel. For safety
reasons, the UC4 system always powers up in MANUAL mode.
Consequently it is important to make sure that the power switch cannot be
accidentally bumped during field operation.
9