UC4™ Total Control™ Automatic Boom Height Technical ... - Norac

More documents

Recommendations

Info

• Control Panel indicates the detection stage as it progresses. 31 The panel will display various messages while it is working. They are for informational purposes only.
8.4.8 STEP 8: <strong>Boom</strong> Geometry Tuning • Do not activate any hydraulic functions during this step. ↓ ↓Release • Release the "AUTO (YES)" switch to continue. Exit cab↓ ⇒ near to ⇒ ↓push ⇒ ↓ground ⇒ ↓Switch ⇒ ↓boom tip ⇒ ↓& let go • Exit the cab of the machine and manually push either boom tip near to the ground for a moment and then let go. * CAUTION!: DO NOT WALK NEAR THE SENSORS WHEN APPROACHING THE BOOM. STAY AT LEAST 3 FEET FROM THE SENSOR IN ORDER NOT TO INDUCE MEASUREMENT ERROR. Push either boom tip such that the tip moves at least 15 inches (more if you can). • Once the control panel has detected your sprayer's geometry, the next menu prompt will appear. • Toggle "SETUP (NO)" or toggle and hold "AUTO (YES)" at this menu to accept the default parameters and continue. *This step is not applicable to system type UK2 32
Page 1 and 2: UC4 Total Control Automatic Boom
Page 3 and 4: UC4 Total Control Automatic Boom
Page 5 and 6: 7 MENU NAVIGATION .................
Page 7 and 8: 2 CHECK YOUR SOFTWARE VERSION The i
Page 9 and 10: 4 GENERAL SYSTEM DESCRIPTION Figure
Page 11 and 12: Another good reason for the main bo
Page 13 and 14: 4.5 CONTROL PANEL The UC4 control p
Page 15 and 16: 5 SYSTEM OPERATION This section out
Page 17 and 18: Table 2 - Examples of Normal Operat
Page 19 and 20: as usual with the boom control swit
Page 21 and 22: 6 UNDERSTANDING YOUR UC4 SYSTEM 6.1
Page 23 and 24: 6.1.5 Sensing Further Ahead of the
Page 25: esponse in CROP mode. The tradeoff
Page 28 and 29: 7.2 MAIN MENU OVERVIEW 23 Table 4 -
Page 30 and 31: 8 SYSTEM SETUP Before the UC4 boom
Page 32 and 33: 8.4 AUTOMATIC SYSTEM SETUP 27 WARNI
Page 34 and 35: 8.4.6 STEP 6: Wiring Test * 29 ⇒
Page 38 and 39: 33 Hold↓ ⇒ ↓AUTO ⇒ ↓Done
Page 40 and 41: If the setup is not done in an acce
Page 42 and 43: ♦ ACTIVE ROLL SYTEM 37 B1. Perfor
Page 44 and 45: 2. Using a tape measure, measure th
Page 46 and 47: The final option would be to add a
Page 48 and 49: 43 6. While viewing the DeadZone ("
Page 50 and 51: 45 Table 7 - Right, Left Booms Boom
Page 52 and 53: 8.9 REMOTE SWITCHES Remote control
Page 54 and 55: 10 STATEMENT OF LIMITED WARRANTY NO
Page 59 and 60: Table 12 - Sprayer Types TYPE Spray
Page 61: SENSOR DISPLAY SETUP Menu Structure

UC4™ Total Control™ Automatic Boom Height Technical ... - Norac

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?