UC4™ Total Control™ Automatic Boom Height Technical ... - Norac
UC4™ Total Control™ Automatic Boom Height Technical ... - Norac
UC4™ Total Control™ Automatic Boom Height Technical ... - Norac
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
8 SYSTEM SETUP<br />
Before the UC4 boom height control system will function properly, some<br />
information about the sprayer and connected sensors is necessary. When<br />
the control panel is turned on for the first time, the UC4 control panel<br />
guides the operator through the <strong>Automatic</strong> System Setup. This procedure is<br />
described in Section 8.4 on page 27. Normally the UC4 system will<br />
automatically configure and calibrate itself to the sprayer. If this process<br />
does not produce the desired results, perform Manual System Setup<br />
described in Section 8.5 on page 36.<br />
8.1 LEVELING CHAINS<br />
NORAC UC4 ultrasonic sensors are calibrated to measure height accurately<br />
when shipped from the factory. However, in order to measure the absolute<br />
height of your spray nozzles, each sensor needs to know how far above the<br />
nozzles it is mounted. To speed up this process, NORAC provides three<br />
leveling chains in the kit that contains the UC4 sensors. These chains are to<br />
be used during the <strong>Automatic</strong>/Manual System Setup procedure.<br />
Before starting the System Setup, attach the leveling chains to your booms.<br />
On the wings, position the chains near the nozzle closest to each outer wing<br />
sensor. Attach the third to one side of the main boom such that it can be<br />
seen from the cab. The chains should just touch the ground when the nozzle<br />
is at a 35-inch height (Figure 12).<br />
25<br />
Figure 12 – Leveling Chain Attached Directly Behind Sensor<br />
8.2 INSTALL (AUTOMATIC SYSTEM SETUP)<br />
The first time the UC4 system is powered up, it will guide you through the<br />
<strong>Automatic</strong> System Setup to customize the UC4 system settings to your