UC4™ Total Control™ Automatic Boom Height Technical ... - Norac

7 MENU NAVIGATION
7.1 NORMAL OPERATING SCREEN
When the control panel is turned on, the LCD screen will flash the current
setup type, followed by the control panel software version. The Normal
Operating Screen will then be displayed (Figure 10). A detailed description
of operating screens is given in Section 5.2 on page 11. The Normal
Operating Screen is the starting point, and ending point, for navigation
through the menu structure.
↓30 MM 35↓
Figure 10 – Normal Operating Screen
The following pages describe the menu prompts that are shown as you
proceed through the SENSOR DISPLAY and SETUP menus. To navigate
through these menus, use the "SENSOR DISPLAY / SETUP (NO)"
toggle switch. Table 4 in the following section shows the structure of the
main menu. The start of the main menu (the Normal Operating Screen) is
shown in bold at the center of the table.
SENSOR
DISPLAY
UC4
BOOM
CONTROL
SENSOR
DISPLAY
+
AUTO
SETUP MANUAL
SETUP
UC4
BOOM
CONTROL
SENSOR
DISPLAY
Figure 11 – SENSOR DISPLAY / SETUP (NO) Switch
The menu is organized in a cyclic fashion, where the "SENSOR DISPLAY
/ SETUP (NO)" switch advances you through the menu. Toggling up on
the switch toward SENSOR DISPLAY will change the menu to the next
higher row shown in Table 4. Toggling down on the switch toward
SETUP (NO) will change the menu to the next lower row shown in the
table. If at any time you wish to return to the Normal Operating Screen,
toggle and hold the "SETUP (NO)" switch down for two seconds. Also, if
you remain in a menu prompt for 30 seconds, the menu prompt will time
out and return to the Normal Operating Screen.
SETUP
+
AUTO
MANUAL
22