2 - Cash Registers

60
EJ REPORT READING AND RESETTING
The cash register provides an electronic journal (EJ) function. This function is intended to record the journal
data in memory instead of journal paper, and print the data as an EJ report. The register records the journal
data in REG, PGM, VOID, X1/Z1 and X2/Z2 modes. By default, a maximum of 2000 lines are stored in memory,
but you can expand it to 3000 lines. For details on EJ programming, please refer to “Electronic Journal
Programming” section (page 45).
Printing journal data on the way of a transaction
You can print journal data of a current transaction recorded in EJ memory by pressing the R key during the
transaction.
This function is valid when the printing style is programmed to receipt, and the receipt ON/OFF
function is set to OFF.
• Sample print
Reading and resetting the electronic journal data (Issuing EJ report)
You can read the journal data stored in the EJ memory in journal format by performing the following procedure in
the X1/Z1 or OP X/Z mode.
To read all of the data:
7:
@
To reset all of the data:
7: P
To read the last 10 records:
710
EJ report title
EJ report end title
A
@
@
A
A
• With EJ memory, a maximum of 2000 (or 3000, if programmed)
lines of data can be stored. When executing an all data
reading, all of the data stored in the EJ memory will be printed.
To save paper, compression print is available.
• To stop reading or resetting the data, turn the mode switch to
“MGR” position. The data will not be erased when resetting.
• When printing is performed continuously, the printing may be
intermitted several seconds. After the intermission, the printing
will be restarted.
• Sample EJ report
Header
information
print
www.cashregisters.net