Download - Projektlabor

;cpi regHigerValueByte,0b10110000 ;//Check if regHigerValueByte has a
specific value
;breq stopthis ;//... and stop here
;rjmp dontstop ;//... or continue
;stopthis: ;//stop here!
;rjmp stopthis
;dontstop: ;//go on and do nothing...
pop regTemp ;//Restore temp
reti
;###################################################################
######################
;# DISPLAY TEST
###################################################################
#######
;//Perform a full featured Display Test
subDisplayTest:
push regTemp ;//Save temp to stack
;// Toggle everz number once
ldi regTemp, 0x00 ;//Reset temp
goon2_subDisplayTest:
out PORTB, regTemp ;//Send Data
ldi regParam, 0x20 ;//Setup how long to delay
rcall delay ;//Wait a short time
cpi regTemp, 0b00001010 ;//IF regTemp = 00001111 then...
breq escape2_subDisplayTest ;//...goto escape2_subDisplayTest
inc regTemp ;//regTemp = regTemp + 1
;// Toggle every digit once
push regTemp ;//Save temp to stack
ldi regTemp, 0x00 ;//Reset temp
goon_subDisplayTest:
out PORTC, regTemp ;//Send Data
ldi regParam, 0x10 ;//Setup how long to delay
rcall delay ;//Wait a short time
cpi regTemp, 0b00001000 ;//IF regTemp = 00001111 then...
breq escape_subDisplayTest ;//...goto escape_subDisplayTest
inc regTemp ;//regTemp = regTemp + 1
rjmp goon_subDisplayTest ;//goto goon_subDisplayTest
escape_subDisplayTest: ;//Leave This Part
pop regTemp ;//Restore temp
;// Done toggle every digit once
rjmp goon2_subDisplayTest ;//goto goon2_subDisplayTest
245