SmartStor NS4600 Product Manual - Promise Technology, Inc.

107
Chapter 6: SmartNAVI
3. Click the Configuration Plugin button.
4. Click the Plug-in you want to remove.
The plug-in’s name turns red.
5. Click the Remove button.
6. Click the Yes button in the confirmation box.
The plug-in is removed from SmartNAVI.
If you need the plug-in later, you can reinstall it. See “Adding Application
Plug-ins” on page 104.
Rebooting the SmartStor
Normally you will only need to reboot the SmartStor is after a firmware upgrade or
a plug-in installation. See “Upgrading the Firmware” on page 213. During the
reboot, none of your folders will be accessible from your networked PCs.
To reboot the SmartStor:
1. Go to the Main Window.
2. Click the NAS Management icon.
3. Click the Shutdown button.
4. Click the Restart option
5. Click the OK button.
6. In the confirmation box, click the Close button.
The reboot runs automatically. When the SmartStor is
fully booted:
• The system status LED turns blue (right)
• The buzzer beeps one time (if the buzzer is
enabled)
See “Enabling and Disabling the Buzzer” on page 162.
Shutting Down the SmartStor
The only time you need to shut down the SmartStor is to replace the disk drive
cooling fan or the power supply. See “Appendix A: Maintenance” on page 213.
During and after the shutdown, none of your folders will be accessible from your
networked PCs.
Using SmartNAVI
To shut down the SmartStor:
1. Go to the Main Window.
2. Click the NAS Management icon.
System Status LED