S90 XS/S70 XS Reference Manual - zZounds.com

More documents

Recommendations

Info

Key Mode Determine how the Arpeggio plays back when playing the keyboard. Settings: sort, thru, direct, sort+direct, thru+direct NOTE: Some Arpeggio types belonging to the “Cntr” Category may not have note events (page 12). When such an Arpeggio type is selected and the Key Mode is set to “sort” or “thru,” no sound is produced even if you press a note on the keyboard. Note Limit Lo/Hi (Note Limit Low/High) Determines the lowest and highest notes in the Arpeggio’s note range. Notes received in this range trigger the Arpeggio. For example, setting a Note Limit of “C5 – C4” lets you trigger the Arpeggio by playing notes in the two ranges of C -2 to C4 and C5 to G8; notes played between C4 and C5 have no effect on the Arpeggio. Settings: C -2 – G8 NOTE: You can also set the Note directly from the Keyboard, by holding down the [SHIFT] button and pressing the desired key. Velocity Limit Lo/Hi (Velocity Limit Low/High) Determines the lowest and highest velocity which can trigger the Arpeggio playback. Arpeggio will only playback for notes received within its specified velocity range. For example, setting a Velocity Limit of 93 – 34 lets you play the Arpeggio from two separate velocity ranges: soft (1 – 34) and hard (93 – 127). Settings: 1 – 127 NOTE: You can also set the velocity value directly from the Keyboard, by holding down the [SHIFT] button and pressing a key. Octave Shift Shifts the pitch of the Arpeggio up or down in octaves. Settings: -10 – +10 Loop When this is set to “on,” the Arpeggio cycles while notes are held. When this is set to “off,” the Arpeggio plays only once even if notes are held. Settings: off, on Trigger Mode When this is set to “gate,” pressing the note starts Arpeggio playback and releasing the note stops it. When this is set to “toggle,” pressing the note starts/stops Arpeggio playback and releasing the note does not affect Arpeggio playback. Normally, this parameter should be set to “gate.” Settings: gate, toggle NOTE: The Trigger Mode “toggle” setting overcomes the Hold “on” setting in the Arpeggio Edit display (page 104). In other words, even when the Hold parameter is set to “on,” pressing the note start/stops Arpeggio playback when the Trigger Mode is set to “toggle.” Accnt Vel Th (Accent Velocity Threshold) Some Arpeggio types include special sequence data called “Accent Phrase,” which will be played back only when the velocities higher than a specified value are received. This parameter determined the minimum velocity that will trigger the Accent Phrase. Settings: off, 1 – 127 Accnt Strt Qtz (Accent Start Quantize) Determines the start timing of the Accent Phrase when the Velocity specified in Accent Velocity Threshold above is received. When set to off, the Accent Phrase starts as soon as the Velocity is received. When set to on, the Accent Phrase starts on the beat specified for each Arpeggio type after the Velocity is received. Settings: off, on sort When you play specific notes (for example, the notes of a chord), the same sequence plays, no matter what order you play the notes. thru When you play specific notes (for example, the notes of chord), the resulting sequence differs depending on the order of the notes. direct Note events of the Arpeggio sequence do not play; only the notes you play on the keyboard are heard. When the Arpeggio plays back, events such as Pan and Brightness are applied to the sound of your tone generator performance. Use this setting when the Arpeggio types include non-note data or when the Category type “Ctrl” is selected. sort +direct The Arpeggio is played back according to the “sort” setting here, and the note pressed is also sounded. thru +direct The Arpeggio is played back according to the “thru” setting here, and the note pressed is also sounded. Reference Manual Reference Basic Structure Multi Voice Performance Multi SEQ Play Master Remote File Audio Rec/Play Utility Play Mixing Edit Select Common Edit Name Arpeggio Controller Effect Parameter Master EQ A/D Out A/D FX Parameter Part Edit Voice Play Mode Arpeggio Arp Edit Arp 1-5 Type Filter/EG 3 Band EQ Rcv Sw FX Send Job Select Recall Bulk Copy Initialize Appendix 106
Random SFX Some Arpeggio types feature a Random SFX function which will trigger special sounds (such as guitar fret noises) when Note Off messages are received. This parameter determines whether the Random SFX is active or not. Settings: off, on SFX Vel Offset (Random SFX Velocity Offset) Determines the offset value by which the Random SFX notes will be shifted from their original velocities. If the resultant Velocity value is less than zero it will be set to 0, and if the resultant Velocity value is greater than 127 it will be set to 127. Settings: -64 – +0 – +63 SFX Key on Ctrl (Random SFX Key On Control) When this is set to “off,” the Random SFX special sound is played with the pre-programmed velocity. When this is set to “on,” the Random SFX special sound is played with the velocity generated when the note is pressed. Settings: off, on Arp 1 – 5 Type (Arpeggio 1 – 5 Type) Determines the settings of the Arpeggio selected on the “Arp Select”. Main Ctgry (Main Category) Sub Ctgry (Sub Category) Determines the Arpeggio Main Category and Sub Category including the desired Arpeggio type. Settings: See “Category List” in the Basic Structure (page 7). Type (Arpeggio Type) Determines the desired Arpeggio Type number from the specified Category. The number and name of the selected Arpeggio Type is shown at the second line on the display. Refer to the Arpeggio Type List in Data List (separate PDF documentation). NOTE: For details about how to use the Arpeggio Type List in Data List (separate PDF documentation), see page 9. Vel Rate (Velocity Rate Offset) Determines the offset value by which the Arpeggio notes will be shifted from their original velocities. If the resultant Velocity value is less than 1 it will be set to 1, and if the resultant Velocity value is greater than 127 it will be set to 127. Settings: -100% – +0% – +100% GTime Rate (Gate Time Rate Offset) Determines the Gate Time (length) of the Arpeggio notes. The Gate Time cannot be decreased beyond its normal minimum of 1; any values outside that range will automatically be limited to the minimum. Settings: -100% – +0% – +100% Reference Manual Reference Basic Structure Multi Voice Performance Multi SEQ Play Master Remote File Audio Rec/Play Utility Play Mixing Edit Select Common Edit Name Arpeggio Controller Effect Parameter Master EQ A/D Out A/D FX Parameter Part Edit Voice Play Mode Arpeggio Arp Edit Arp 1-5 Type Filter/EG 3 Band EQ Rcv Sw FX Send Job Select Recall Bulk Copy Initialize Appendix 107
Page 1 and 2:
How to Use This Manual The S90 XS/S
Page 3 and 4:
Tone Generator Block The tone gener
Page 5 and 6:
Elements and Drum Keys Elements and
Page 7 and 8:
Multi A/D Input Block A program in
Page 9 and 10:
How to Use the Arpeggio Type List T
Page 11 and 12:
Arpeggio Playback Types The Arpeggi
Page 13 and 14:
Controller Block This block consist
Page 15 and 16:
Effect Connection in Each Mode Voic
Page 17 and 18:
Delay An effect (or device) that de
Page 19 and 20:
Effect Parameters VCM (Virtual Circ
Page 21:
Parameter name Descriptions Drive R
Page 24 and 25:
Internal Memory As you use this ins
Page 27:
Voice Mode Voice Play The Voice mod
Page 32:
Using the Arpeggio Function The Arp
Page 35 and 36:
PB Range Upper (Pitch Bend Range Up
Page 37 and 38:
Velocity Rate Determines how much t
Page 39 and 40:
Random SFX Some Arpeggio types feat
Page 41 and 42:
Phase Determines the starting phase
Page 43 and 44:
User LFO Cycle Determines the amoun
Page 45 and 46:
Chorus To Reverb Determines the Sen
Page 47 and 48:
Tempo Sync (Delay Tempo Sync) Deter
Page 49 and 50:
Time Velocity Sens (EG Time Velocit
Page 51 and 52:
Cutoff Key Follow (Cutoff Key Follo
Page 53 and 54:
Filter Scale Break Point 1 - 4 Dete
Page 55 and 56: Segment (EG Time Velocity Sensitivi
Page 57 and 58: EQ Type (EQ Type) Determines the EQ
Page 59 and 60: 7 Effect Same as the Effect in Norm
Page 61 and 62: Reverb Send (Key Reverb Send) Deter
Page 63 and 64: Voice Job The Voice Job mode featur
Page 65 and 66: Setting examples of the Destination
Page 67 and 68: Combination Type Filter This type i
Page 69 and 70: Performance Mode Performance Play T
Page 73 and 74: Performance Edit Performance Edit c
Page 75: Arp Tempo (Arpeggio Tempo) Determin
Page 78 and 79: Effect Parameter 1 - 16 The effect
Page 80 and 81: Effect Parameters Switch Determines
Page 82 and 83: 2 Play Mode Volume Adjusts the Volu
Page 84 and 85: Vel Sens Offset (Velocity Sensitivi
Page 86 and 87: Velocity Mode Adjusts the velocity
Page 88 and 89: 4 Filter/EG Cutoff Determines the c
Page 90 and 91: Performance Job The Performance Job
Page 92: Supplementary Information Performan
Page 96: Arp Tempo (Arpeggio Tempo) Determin
Page 99 and 100: 7 A/D FX (A/D Effect) From this dis
Page 101 and 102: Part Edit Part Edit lets you edit t
Page 103 and 104: Velocity Limit Lo/Hi (Velocity Limi
Page 105: Gate Time Rate Determines how much
Page 109 and 110: 6 Rcv Sw (Receive Switch) From this
Page 111: Voice This convenient operation let
Page 115 and 116: Master Mode The Master mode offers
Page 117 and 118: 3 Zone Sw (Zone Switch) Zone Switch
Page 119 and 120: 2 Note From this display you can se
Page 121 and 122: Master Job The Master Job mode feat
Page 123 and 124: Remote Mode In the Remote mode, you
Page 126: File Mode The File mode provides to
Page 130 and 131: File Job In the File Job display, d
Page 133 and 134: Utility Mode In the Utility mode, y
Page 135 and 136: Knob Curve Adjusts the touch respon
Page 137 and 138: 2 MIDI This lets you set the MIDI s
Page 139 and 140: 3 Controller Determines Controller
Page 141 and 142: Output Select Determines the output
Page 143 and 144: Master EQ (Voice Master EQ) This di
Page 145 and 146: 8 Panel Lock Determines which butto
Page 147 and 148: Port 2 This port is used to control
Page 149 and 150: Brightness (Control #74) Messages w
Page 151 and 152: System Messages System messages are
Page 153 and 154: LCD Indication Description Load All
Page 155 and 156: Are the parameter settings such as
Page 157 and 158:
Wrong pitch or unexpected pitch Is
Page 159 and 160:
The S90 XS/S70 XS does not sound pr
show all

S90 XS/S70 XS Reference Manual - zZounds.com

Create successful ePaper yourself

Delete template?

Save as template?