S90 XS/S70 XS Reference Manual - zZounds.com
S90 XS/S70 XS Reference Manual - zZounds.com
S90 XS/S70 XS Reference Manual - zZounds.com
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Velocity Limit Lo/Hi (Velocity Limit Low/High)<br />
Determines the minimum and maximum values of the velocity range within which each Part will respond. Each Part will<br />
only sound for notes played within its specified velocity range. If you specify the maximum value first and the minimum<br />
value second, for example “93 to 34,” then the velocity range covered will be “1 to 34” and “93 to 127.”<br />
Settings: 1 – 127<br />
NOTE: You can also set the Velocity value directly from the Keyboard, by holding down the [SHIFT] button and pressing a key.<br />
Split Lo/Up (Split Lower/Upper)<br />
Determines which area of the keyboard will produce the sound. When “upper” is selected, the notes of the Split Point<br />
(Common parameter) or upper will produce the sound. When “lower” is selected, the notes lower than the Split Point<br />
(Common parameter) will produce the sound. When “both” is selected, all the notes of the entire keyboard will produce<br />
the sound. Actually, the sound is produced by playing the notes within the area that matches both the settings here and<br />
the Note Limit setting.<br />
Settings: both, lower, upper<br />
Porta Sw (Portamento Switch)<br />
Determines whether Portamento is applied to each Part or not.<br />
Settings: off, on<br />
NOTE: For Parts to which the Drum Voice is assigned, this parameter is not available.<br />
Porta Time (Portamento Time)<br />
Determines the pitch transition time. Higher values result in a longer pitch change time, or a slow speed.<br />
Settings: 0 – 127<br />
NOTE: For Parts to which the Drum Voice is assigned, this parameter is not available.<br />
Porta Mode (Portamento Mode)<br />
Determines how Portamento is applied to your keyboard performance.<br />
Settings: fingered, fulltime<br />
NOTE: For Parts to which the Drum Voice is assigned, this parameter is not available.<br />
Output Select<br />
Determines the specific output(s) for the individual Part. The following settings are available. You can assign each<br />
individual Part sound to be output from a specific hardware output jack on the rear panel.<br />
NOTE: The Reverb Send, Chorus Send and Dry Level parameters are not available when Output Select is set to something other than<br />
“L&R.”<br />
Settings: L&R, asL&R, asL, asR, drum (only Drum Voice)<br />
Vel Sens Depth (Velocity Sensitivity Depth)<br />
Determines the degree to which the resulting volume of the tone<br />
generator responds to your playing strength. The higher the value, the<br />
more the volume changes in response to your playing strength (as<br />
shown at the right). When this is set to 0, the volume remains the same<br />
no matter how strongly or softly you play. This would be useful, for<br />
example, for authentic playing of an Organ Voice.<br />
Settings: 0 – 127<br />
fingered Portamento is only applied when you play legato (playing the next note before releasing the previous one).<br />
fulltime Portamento is applied to all notes.<br />
<strong>Reference</strong> <strong>Manual</strong><br />
When Offset (below) is set to 64:<br />
127<br />
Actual resulting<br />
velocity<br />
(affecting the tone<br />
generator)<br />
Depth=127 Depth=64<br />
0<br />
Velocity with which<br />
you play a note<br />
127<br />
<strong>Reference</strong><br />
Depth=32<br />
Depth=0<br />
Basic Structure<br />
Voice<br />
Performance<br />
Multi<br />
SEQ Play<br />
Master<br />
Remote<br />
File<br />
Audio Rec/Play<br />
Utility<br />
Performance<br />
Play<br />
Mixing<br />
Edit Select<br />
Common Edit<br />
Name<br />
Play Mode<br />
Arpeggio<br />
Controller<br />
Filter / EG<br />
EQ<br />
Effect<br />
Parameter<br />
A/D Out<br />
A/D FX<br />
Parameter<br />
Part Edit<br />
Voice<br />
Play Mode<br />
Arpeggio<br />
Arp Edit<br />
Arp 1-5 Type<br />
Filter / EG<br />
3 Band EQ<br />
Rcv Sw<br />
FX Send<br />
Job Select<br />
Recall<br />
Bulk<br />
Copy<br />
Initialize<br />
Supplementary Info.<br />
Appendix<br />
83