Sidewinder G2 6.1.1 Administration Guide - Glossary of Technical ...

Creating proxy rules
5. [Optional] To create a network object for this rule, do the following:
a. Click New. You will be prompted to select the type of object you
want to create.
b. Select the type of network object you want to create and click OK.
The New Network Object window appears.
c. Create the network object. When you click Add, you are returned to
the Source/Dest tab in the Proxy Rule window.
Note: For information on creating a Network Object, see “Creating network objects”
on page 5-10.
6. [Conditional] In the NAT Address drop-down list, select the object (IP
address or host) that will replace the original source address when it is
translated.
Note: If you selected a netmap in the Source field, the appropriate NAT properties
are automatically supplied based on the mapping configured for each IP address or
subnet in that netmap. For more information on netmaps, see “Netmap network
objects” on page 4-10.
Note: Do not set the NAT Address to localhost if you are using a virtual burb as your
destination burb.
7. [Conditional] In the Redirect Host drop-down list, select the host or IP
address to redirect the original destination.
Note: If you selected a netmap in the Destination field, the appropriate redirection
properties are automatically supplied based on the mapping configured for each IP
address and subnet in that netmap. For more information on netmaps, see “Netmap
network objects” on page 4-10.
8. [Conditional] In the Redirect Port field, type the port number on which
the connection will be redirected.
Creating Rules and Groups 7-7