Sidewinder G2 6.1.1 Administration Guide - Glossary of Technical ...

Figure 7-13. IP Filter
General Properties
window
About the IP Filter General
Properties window
Selecting your active policy rules
Viewing and modifying general IP Filter properties
There are a number of IP Filter properties that affect all active IP Filter
rules. To view or modify these properties, in the Admin Console select
Policy Configuration -> Rules and then click View Active Policy -> IP Filter
Properties. The IP Filter General Properties window appears.
The IP Filter General Properties window allows you to specify basic
properties that apply to all IP Filter rules contained in the IP Filter
portion of the active policy. Follow the steps below.
1. In the Maximum TCP Sessions field, specify the maximum number of
TCP sessions allowed to use the IP Filter at one time. Valid values are
0–1000000.
2. In the Maximum UDP Sessions field, specify the maximum number of
UDP sessions allowed to use the IP Filter at one time. Valid values are
0–1000000.
3. In the Start of reserved ports field, specify the starting port that IP Filter
will reserve for its own use. Valid values are 1024–65533. The default is
38000.
4. In the Number of ports reserved for ipfilter field, specify the number of
ports IP Filter will reserve for its own use. Valid values are 1–64509. The
default is 200.
5. Click OK to save your changes, or click Cancel to reset the fields to the
values that were previously entered.
Creating Rules and Groups 7-25