You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Installing the E-MU 1010 PCI Card<br />
This installation is very simple but if you are not familiar with the installation of<br />
computer peripherals and add-in boards, please contact your authorized E-MU<br />
Systems dealer or an approved computer service center to arrange for the installation.<br />
To install the 1010 PCI card into your computer<br />
1. Make sure that the power switch on your computer is off.<br />
IMPORTANT: Unplug the power cord from the wall outlet!<br />
2. Touch a metal plate on your computer to ground yourself and to discharge any<br />
static electricity.<br />
3. Follow the computer manufacturer’s recommended procedure for opening the<br />
case.<br />
4. Remove the metal bracket from one PCI slot. If you have the E-MU 1212M system<br />
or the Sync Daughter Card you’ll need to remove the bracket from two PCI slots.<br />
Put the screw(s) aside for use later. See figure 1 below.<br />
Figure 1 Figure 2<br />
(may not be present<br />
on your computer)<br />
ISA Slots<br />
PCI Slots<br />
5. Align the E-MU 1010 PCI card with the slot and press gently but firmly down into<br />
the slot as shown in figure 2.<br />
6. Do not force the E-MU 1010 card into the slot. Make sure that the gold finger<br />
connector of the card is aligned with the PCI bus connector on the motherboard<br />
before you insert the card into the PCI slot. If it doesn’t fit properly, gently remove<br />
it and try again.<br />
7. Secure the card into the slot using one of the screws you placed aside earlier.<br />
2 - Installation<br />
Installing the E-MU 1010 PCI Card<br />
Note: Some<br />
computer cases don’t use<br />
screws to secure PCI cards.<br />
In this case, follow the<br />
instructions that came<br />
with your computer.<br />
E-MU PCI Digital Audio Systems 15
Change language