AR-M237 AR-M277 - Pitney Bowes Canada

INTERRUPTING A COPY RUN
A copy run can be temporarily interrupted to allow another copy job to be performed. When the other job is finished,
the copy run will resume using the original copy settings.
1
2
3
ACC.#-C
34
Note
Press the [INTERRUPT] key ( ) to
interrupt the copy run.
The [INTERRUPT] key
( ) blinks until the
machine is ready for the
interrupt job, after which
it lights steadily.
Note
Automatic two-sided copying, sort/group copying, staple sort, pamphlet copy, job build, cover copy, job build, job
programs, or multi shot copying cannot be used for interrupt copying.
If you decide to cancel
the interrupt job while
selecting settings, press
the [INTERRUPT] key
( ).
If audit mode is enabled, a message will
appear prompting you to enter your
account number. Enter your account
number with the numeric keys. The copies
that you make will be added to your
account’s count.
If an original is being scanned when the
[INTERRUPT] key ( ) is pressed, the
interrupt job will begin after the original is
scanned. If a copy is being printed, the
interrupt job will begin after the copy is
printed.
Remove the previous original(s) and
place the original(s) of the interrupt
copy job. (p.22, p.23)
Select the number of copies and any
other desired copy settings, and then
press the [START] key ( ).
The interrupt copies will
be offset from the
previous copies. (Offset
function, p.35)
4
5
When the copy job is finished, press
the [INTERRUPT] key ( ) and remove
the original(s).
Replace the previous original(s) and
press the [START] key ( ) to resume
copying.
Replace only the originals that have not yet been
scanned.