AR-M237 AR-M277 - Pitney Bowes Canada
AR-M237 AR-M277 - Pitney Bowes Canada
AR-M237 AR-M277 - Pitney Bowes Canada
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
DISPLAY MESSAGES<br />
If one of the following messages appears in the display, take prompt action as instructed by the message.<br />
58<br />
Message Cause and solution Page<br />
ENTER YOUR ACCOUNT<br />
NUMBER.<br />
Auditing mode is enabled. Enter your account number.<br />
56<br />
A MISFEED HAS OCCURRED. Remove the misfeed as explained in "MISFEED REMOVAL". 64<br />
2-SIDED COPIES CANNOT BE<br />
MADE ON THIS PAPER TYPE.<br />
REMOVE PAPER FROM THE<br />
TRAY.<br />
This appears when you attempt to make two-sided copies on special<br />
paper that cannot be used for two-sided copying. Cancel two-sided<br />
copying or change the paper.<br />
The indicated output tray is full. Remove the output from the tray.<br />
( indicates the tray that is full.)<br />
CLOSE THE COVER. The indicated cover is open. Close the cover. ( indicates the<br />
cover that is open.)<br />
PLEASE EXTEND BYPASS-TRAY. When copying from the bypass tray, be sure to pull out the bypass<br />
tray extension.<br />
COVER SHEETS MUST BE THE<br />
SAME SIZE AS THE COPY<br />
PAPER USED.<br />
SELECTED PAPER TRAY IS<br />
PROHIBITED. PLEASE SELECT<br />
ANOTHER PAPER TRAY.<br />
PLEASE CHECK THE PAPER<br />
SIZE OF TRAY .<br />
15, 27<br />
When adding a cover, load paper in the bypass tray that is the<br />
same size as the paper in the tray selected for copying. 48<br />
TONER SUPPLY IS LOW. The toner cartridge must be replaced soon. 72<br />
CHANGE THE TONER C<strong>AR</strong>TRIDGE. The toner cartridge is out of toner. Replace the toner cartridge. 72<br />
CHECK THE TONER C<strong>AR</strong>TRIDGE. Make sure that the toner cartridge is installed correctly. 72<br />
THE DOCUMENT FEEDER IS<br />
DISABLED.<br />
The RSPF has been disabled in the key operator programs. Use<br />
the document glass.<br />
This appears when a tray is selected that has been prohibited in<br />
22<br />
"TRAY SETTINGS" in the custom settings. 53<br />
The tray's paper size setting is different from the actual paper size.<br />
Load the correct size of paper. The tray is indicated in .<br />
ADD STAPLES. The finisher is out of staples. Replace the staple cartridge as<br />
explained in "STAPLE C<strong>AR</strong>TRIDGE REPLACEMENT".<br />
PLEASE REMOVE PAPER FROM Paper remains in the stapler compiler. Remove the paper.<br />
THE STAPLER COMPILER.<br />
MEMORY IS FULL. PRESS [ST<strong>AR</strong>T]<br />
TO BEGIN COPYING OR [CA] TO<br />
CANCEL.<br />
The memory becomes full while scanning originals. Press the<br />
[ST<strong>AR</strong>T] key ( ) to copy only the originals that have been<br />
scanned, or press the [CLE<strong>AR</strong> ALL] key ( ) to cancel the job.<br />
-<br />
-<br />
18<br />
15<br />
73<br />
70<br />
-
Change language