Price List July 2012 - Knoll

Spine ends and connectors
3 1 /2 spine extender kit for use with ceiling infeed or panels
AutoStrada
description application h w d pattern no. list
Spine extender kit for use
with Currents Spine
Spine extender kit for use
with AutoStrada Spine
39h spine 39 5 4 AX1SX39 C (L/C/P)( )( )( ) $499.
48h spine 48 5 4 AX1SX48 C (L/C/P)( )( )( ) 516.
64h spine 64 5 4 AX1SX64 C (L/C/P)( )( )( ) 610.
39h spine 39 5 4 AX1SX39 A (L/C/P)( )( )( ) 610.
48h spine 48 5 4 AX1SX48 A (L/C/P)( )( )( ) 626.
64h spine 64 5 4 AX1SX64 A (L/C/P)( )( )( ) 726.
Spine and linkable screens
Order Code
Specification Information
Application Notes
Example: AX1 SX 48 AL 613 613
613
AX1 Spine connector
SX Type
48 Spine height
A Spine type
L Crown end type
613 Vertical finish
613 Base trim finish
613 Top cap finish
For all 3 1 /2 spine extenders specify
spine base type:
A AutoStrada
C Currents
Then specify crown end type.
L=Flat low/high profile metal crown
end cap
C=Standard and compact sloped
end cap
P=Power Pole
Then specify finish for vertical trim
covers, all standard painted
finishes.
Then specify base cover finish.
AutoStrada spine base covers are
clear anodized aluminum (AA) or
painted finish excluding silver.
Currents spine raceway covers are
available in any painted finish only.
Then specify top cap finish (if
applicable).
Spine extenders include brackets,
side and top trim covers between the
end of a spine and any spine end
connector to add 3 1 /2 to the length
of a spine.
Spine end connector must be
specified separately to finish off
face of spine extender.
Spine extender dimension matches
that of the Currents 3 1 /2x5 ceiling
infeed panel which may be added
between nominal spine height and
ceiling for connection to building
power, data and communications
supply.
This extension can also make up for
the dimensional gain of one
Dividends Horizon panel or screen
in the middle of a cluster of
workstations.
In most cases the spine end
connector matches the height of the
attached Dividends Horizon panel
or screen, but the extending area is
only as high as the nominal height
of the spine (bottom of crown) so the
crown always requires an end cap.
When attached panel or screen is
lower than the spine, the spine end
connector should be the same height
as the nominal height of the spine.
65