Sun Fire V445 Server Administration Guide - SCN Research

For instructions on connecting to the ALOM system controller, see:
■ “Using the Serial Management Port” on page 39
■ “Activating the Network Management Port” on page 40
▼
To Log In to the ALOM System Controller
Note – This procedure assumes that the system console is directed to use the serial
management and network management ports (the default configuration).
1. If you are logged in to the system console, type #. to get to the sc> prompt.
Press the hash key, followed by the period key. Then press the Return key.
2. At the login prompt, enter the login name and press Return.
The default login name is admin.
Sun(tm) Advanced Lights Out Manager 1.1
Please login: admin
3. At the password prompt, enter the password and press Return twice to get to the
sc> prompt.
Please Enter password:
sc>
Note – There is no default password. You must assign a password during initial
system configuration. For more information, see your Sun Fire V445 Server
Installation Guide and Sun Advanced Lights Out Manager (ALOM) Online Help.
Caution – In order to provide optimum system security, best practice is to change
the default system login name and password during initial setup.
Using the ALOM system controller, you can monitor the system, turn the Locator
indicator on and off, or perform maintenance tasks on the ALOM system controller
card itself. For more information, see:
■ Sun Advanced Lights Out Manager (ALOM) Online Help
Chapter 5 Managing RAS Features and System Firmware 99